Autopapyrus · Audi A6 C6 2.0 TFSI (BPJ, 2006)
https://autopapyrus.com/catalog/audi/a6/guides/battery-replacement/
https://autopapyrus.com/catalog/audi/a6/guides/battery-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Audi A6 C6 2.0 TFSI (BPJ, 2006): Battery Replacement
On the Audi A6 C6 the battery is located in the trunk, under the floor on the right side. Replacement is not difficult, but afterward the new battery must be registered in the vehicle electrical system control module with a diagnostic tool (VCDS, OBDeleven or equivalent). Without this, charging may not work correctly and the new battery's service life will be shortened.
Key figures
- Battery replacement intervalabout 4 years. This is a guideline for replacing the battery ahead of time so you are not left with a car that will not start (step 1)
Check these values against the manufacturer’s specification for your vehicle before you start.
Part
| № | Part | Alternatives |
|---|---|---|
| 01 | 12 V battery, AGM or starter typecapacity and cold cranking current same as the old batteryFind on Amazon → | AlternativesVartaBoschExide |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
6- Sockets and wrenches (sizes depend on the terminal clamps and hold-down bracket, so match them on the car) Amazon →
- screwdriver Amazon →
- torque wrench Amazon →
- battery charger or memory saver (power supply keeper for the vehicle electrical system) Amazon →
- gloves and safety glasses Amazon →
- terminal cleaning tool Amazon →
There's a full repair manual for this car
Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online) and 3 more.
See manuals →
Step by step
13 steps- Park the car on level ground, shut off the engine, turn off all electrical consumers and remove the key. Wait a few minutes for the control modules to go to sleep. If you want to preserve the car's settings, connect an external memory saver.
- Open the trunk and lift the main floor panel (the spare wheel or tire repair kit area). On the right side, find the plastic cover. The battery is underneath it.
- Remove the battery cover. If a vent hose is fitted to the battery, note how it is routed and where it exits the car.
- Disconnect the negative terminal (black) first, then the positive terminal (red, with a protective cap). Secure the removed terminals so they do not touch the body or each other.
- Remove the battery hold-down bracket and detach the vent hose from the port on the old battery.
- Lift out the battery. It is heavy (usually 20-30 kg), so lift it with both hands and bend your knees. Do not lift it over the rear bumper edge/sill area.
- Wipe the battery tray and clean oxidation from the terminals. Inspect the vent hose and its outlet to the outside. It must not be clogged or torn.
- Install the new battery in the same position, with the vent port facing the vent outlet. Connect the vent hose.
- Tighten the hold-down bracket so the battery cannot be moved by hand, without crushing the case. For the exact torque, follow the manufacturer's specification.
- Connect the positive terminal first, then the negative. Tighten the terminals moderately, approximately 5-8 N·m (4-6 lb-ft) (for the exact value, follow the manufacturer's specification). Do not overtighten, to avoid damaging the battery posts. Put the protective cap back on the positive terminal.
- Connect the diagnostic tool and register the new battery (battery replacement in the vehicle electrical system control module): enter the type, capacity and manufacturer. The exact procedure depends on the tool.
- Check the operation of the power windows (perform their initialization if necessary), the clock and the multimedia system. If the radio asks for a code, enter it (it is in the service booklet or on the radio code card).
- Start the engine, make sure there are no fault messages on the instrument cluster, then close the battery cover and the trunk floor panel.
Common mistakes and warnings
- The battery contains acid and gives off explosive gas
- Keep sparks and open flames away, and wear gloves and safety glasses
- Do not reverse the polarity
- Take the old battery to a recycling point
- Do not throw it away
- If errors appear after replacement, the engine does not start or systems do not work, take the car to a repair shop with diagnostic equipment
- The torque values above are approximate, so check the exact values against the manufacturer's specification
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of Audi
Audi AG is a German company and part of the Volkswagen Group, best known for building Audi cars.
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →