← H1 Hyundai H1 repair manuals →

Hyundai H1 2.5 CRDi D4CB (2007): Starting the Engine Correctly

The 2.5 CRDi common rail diesel starts after the glow plugs finish preheating. Wait for the glow plug indicator to go out, and don't put the engine under load right after it starts. These rules protect the starter, the battery and the turbocharger.

DifficultyEasy Time1-2 minutes Steps8 ToolsNone needed

Key figures

  • Maximum starter run time per attemptdon't hold the key in START longer (step 4)
    10 seconds
  • Pause before restartingafter a failed attempt, return the key to LOCK, then to ON again and wait for the indicator to go out (step 5)
    10 seconds with the key in LOCK
  • Idle time before shutting off after hard drivingso the turbocharger cools down (step 8)
    about 1 minute
  • Fuel filter indicator when the ignition is switched onthis is the normal bulb check; if it comes on while the engine is running, there is water in the filter (step 7)
    on for about 3 seconds

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№Part
01 Not requiredFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online) and 1 more. See manuals →

Step by step

8 steps
  1. Get in the car, put the shift lever in neutral (manual transmission) or P/N (automatic transmission) and apply the parking brake. On a manual, press the clutch pedal. Switch off unnecessary loads: lights, heating, the radio.
  2. Turn the key to ON, without going all the way to START. The glow plug indicator (a coil symbol) comes on in the instrument cluster. The engine is preheating.
  3. Wait until the indicator goes out. The time depends on the coolant temperature, the air temperature and the condition of the battery. It is longer in cold weather and barely noticeable on a warm engine.
  4. When the indicator has gone out, turn the key to START and hold it until the engine starts. Hold it for no more than 10 seconds, then release the key.
  5. If the engine hasn't started within 10 seconds after preheating ends, return the key to LOCK and wait 10 seconds. Then turn it to ON again and wait for the indicator to go out. Only then try starting again.
  6. After the engine starts, don't rev it or run it at high rpm. On a cold engine, let it idle for a few seconds so oil reaches the turbocharger. Then pull away smoothly, keeping rpm low until the engine warms up.
  7. Check the instrument cluster. The fuel filter indicator comes on for about 3 seconds when you turn the ignition on, then goes out. If it comes on while the engine is running, water has collected in the fuel filter and must be drained. Don't drive with the indicator on: power drops, and the common rail fuel system can be damaged.
  8. Shutting off the engine. After fast driving or a long drive under load, let the engine idle for about 1 minute, then switch off the ignition. This lets the turbocharger cool down. Don't shut the engine off right after heavy load: you can seriously damage the engine or the turbocharger.

Common mistakes and warnings

  • If the glow plug indicator stays on or flashes after the engine has warmed up or while driving, the system has a fault
  • Have it diagnosed at a repair shop as soon as possible
  • Don't crank the starter for long periods or make several attempts in a row: this drains the battery and overheats the starter
  • If the engine still won't start, look for the cause (battery, glow plugs, fuel, air in the system)
Spotted a mistake? Tell us →

Our articles

More articles →