Autopapyrus · Luxgen 7 SUV (2014)
https://autopapyrus.com/catalog/luxgen/luxgen7-suv/guides/replacing-a-fuse-in-the-interior-fuse-box/
https://autopapyrus.com/catalog/luxgen/luxgen7-suv/guides/replacing-a-fuse-in-the-interior-fuse-box/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Luxgen 7 SUV (2014): Replacing a Fuse in the Interior Fuse Box
The interior fuse box in the Luxgen 7 SUV is located in the cabin on the driver's side, under the instrument panel or at the end of the dashboard, and is covered by a plastic lid. The back of the lid usually has a diagram with the amperage ratings. The replacement requires no tools. The key is to install a fuse with the same amperage rating.
Part
| № | Part | Alternatives |
|---|---|---|
| 01 | Blade fuses (standard or mini)same amperage rating and color as the blown fuseFind on Amazon → | AlternativesBoschLittelfuseHella |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
3Step by step
11 steps- Turn off the engine, switch off the ignition and all electrical loads (lights, radio, heated seats and so on), and remove the key.
- Locate the fuse box on the driver's side: look under the lower left part of the dashboard and check the end of the dashboard with the driver's door open. Use a flashlight for light.
- Remove the fuse box cover: pry it off with your finger or a plastic trim tool by the slot, and release the clips. Do not jerk it or use metal tools.
- Find the diagram on the back of the cover or in the owner's manual. Identify the fuse for the circuit you need (cigarette lighter/power outlet, radio, power windows, heating and so on) and its amperage rating.
- Pull the fuse out with the fuse puller, pulling straight out. Do not rock it side to side, to avoid damaging the terminals.
- Hold it up to the light: a blown fuse has a broken element or a darkened housing. You can also check it with a multimeter in continuity mode.
- Choose a new fuse of the same size and the same amperage rating (the number in amps is printed on the body, and the color corresponds to the rating).
- Push the new fuse all the way into the same terminals.
- Turn the ignition on and check that the circuit works.
- If the fuse blows again, do not install one with a higher rating. The cause is a short circuit or an overload in the circuit: inspect the wiring and the connected devices (chargers, dash cams, radio).
- Snap the cover back into place until it clicks. Put the spare fuses and the fuse puller back in the box.
Common mistakes and warnings
- Never install a fuse with a higher amperage rating or bridge it with a piece of wire or foil: the wiring will overheat and a fire may result
- Replace a fuse only with the ignition off
- If the fuse blows again right after replacement or you smell burning, take the car to a repair shop to trace the short circuit
- The location of the box and the numbering of the slots may vary by trim level, so follow the diagram on the cover