← CX-5 Mazda CX-5 repair manuals →

Mazda CX-5 (1st Generation): Front Door Panel Removal and Installation

The front door panel on the first-generation CX-5 is held by screws and plastic retaining clips. The key point is that the panel must not be pulled upward (as on older models), or the upper hooks and pins will break. Removal is needed to replace speakers, repair window regulators, install sound deadening, or replace the door latch.

DifficultyMedium Time30-40 minutes Steps11

Parts

2
№Part
01 Plastic door panel clips (retainer diameter about 10 mm)if damagedFind on Amazon →
02 Screw cover capsif damagedFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

6

Read the codes yourself

A scanner plugged into the OBD2 port under the dashboard shows which fault codes the car has stored, before you buy any parts. Cars sold in the US from 1996, and petrol cars in Europe from 2001 (diesels from 2004), have this port.

  • Basic code reader, about $20–40: reads and clears engine codes Amazon →
  • Bluetooth scanner with a phone app, about $30–100: live sensor data, and on many cars ABS and airbag codes too Amazon →

Check that the scanner lists your make and model year before you buy. We may earn a commission from qualifying purchases.

There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online) and 1 more. See manuals →

Step by step

11 steps
  1. Lower the window all the way down, open the door fully, and disconnect the negative battery terminal (if you unplug connectors with the power on, there is a risk of control module errors).
  2. Pry out the rubber cover in the armrest recess (behind the power window switch block) with a plastic trim tool and remove it.
  3. Pry off the decorative trim behind the door pull handle (from inside the recess) and remove it.
  4. Remove the Phillips screw behind the door pull handle (under the trim you just removed).
  5. Remove the Phillips screw in the lower part of the armrest recess (under the rubber cover from step 2).
  6. Wrap a flat-head screwdriver or plastic trim tool with electrical tape, insert it between the bottom edge of the door panel and the door metal, and pull toward you. Release the clips along the entire bottom edge and along the sides.
  7. Release the upper inner corner of the panel (near the side mirror). There is one clip there.
  8. Pull the panel away from the door (strictly perpendicular to the door surface, NOT upward) and free it from the top edge, where the panel hooks onto the metal lip of the door frame.
  9. Move the panel 10-15 cm (4-6 in) away from the door, press the locking tabs on the power window switch and central locking connectors, and disconnect the connectors.
  10. Remove the panel completely. Inspect the clips and replace any broken ones with new ones (pull the old ones out of the panel's sockets and press in new ones until they click).
  11. Install in reverse order: first connect the connectors, hook the top edge of the panel onto the door frame, align all the clips with the holes in the metal, press around the perimeter with your palm until the clips click, install the screws (do not overtighten, or the plastic will crack), then install the cover caps and trim.

Common mistakes and warnings

  • Do not pull the panel upward
  • On the CX-5 the upper mounts are hooks and pins that break under vertical force
  • Pull strictly away from the door
  • If you disconnect the connectors with power on (without disconnecting the negative battery terminal), a fault code may be logged in the comfort control module
Spotted a mistake? Tell us →

Our articles

More articles →