Air suspension not working on Hyundai Equus
Fault code C1620 – 1st set-up not completed is stored. As I understand it, the height sensor calibration procedure has not been carried out. The MaxiSus Pro scanner has this function, but when I start it, it shows the message "test conditions not met". The car is on level ground, ignition on, selector in P, doors closed. I can't hear the compressor running, although there is pressure in the system. Can anyone help with the wiring diagram? The problem started in the cold weather. The compressor was blamed, and it sometimes blew a fuse. The owner had doubts. The compressor was tested and is fine. The suspension is in the lowest position. Is there any information? Please share.
C1620 is a general fault code that appears when the suspension position cannot be changed within a set time. The fault can be mechanical or electrical. The calibration procedure won't run because there are DTCs present.
I've come across this on other cars. Check the sensors.
Problem solved. Before running the calibration, the system has to be filled. The car is raised on a lift, you select system fill in the special functions, and you supply pressure through the service fitting with a compressor. After that you lower the car and run the calibration.
That's nonsense. We service all sorts of cars here, and I've never seen such a stupid algorithm )))
On the Equus it really is like that. Raise it on a lift, fill the system to 11-12 atm, fill the air springs (not a typo), check the pneumatic valve, check the atmospheric pressure sensor, then finish the check procedure. Data: 105-bar receiver (as written), 46 air spring. That is enough. Then comes the learning procedure, during which both the rear and the front go up and down, then settle at the middle position, and the scanner asks you to confirm the current height. OK, the system is learned and filled. All these gyrations are because the air suspension system on this car is CLOSED.
I sent the fault code by e-mail.
Could you clarify a little? On the Kia Quoris, according to the manual, after replacement the system must be filled with a 12 bar compressor. Then are the checks a separate function, or is it all done during the initial calibration? (There is also a non-initial calibration, where the car goes down and up and is normal.) Without a compressor that gives 12 bar, we fill it with the original compressor, but then the calibration won't start and says stabilization NOT COMPLETED. Also, according to the manual, the car must be put in normal mode, but that function also doesn't run and gives a DTC error. What do you think: is a fitting with 12 bar pressure required for calibration? The guys tell me even more is needed.....
Hello. Can anyone tell me what adapter is needed to fill the system? I've been to several service stations, and they say the fitting is non-standard and they can't connect to it.