Subaru Forester 2.0 L: unable to clear the fault codes
Subaru Forester 2.0 L, 2007. The car came back from a service shop where they replaced the first oxygen sensor. They couldn't clear the codes with a Launch. I couldn't clear them either, trying Scandoc, Autocom and an MT10. The codes present were P0171 System Too Lean (Bank 1), 0107 MAP sensor circuit short to ground, and P0607 Throttle Control System Circuit Range Performance. P0607 is active and the others are inactive. Where should I look and what should I do?
Selecting the make in the Launch doesn't clear codes on a SUBARU. I clear them by selecting generic OBD. The same goes for the MT10. P.S. I have the same Subaru.
Check the throttle. What does Scandoc show for it?
On the MT10 nothing clears, either through OBD or through Subaru. Scandoc shows the same codes. When I try to erase them, it says to turn the ignition off and on, but it doesn't help.
Strange. On the MT10, are you connecting through OBD over CAN? Was the MT10 updated recently?
Which MT10 are we talking about? Mine is from NPP "NTS". Which protocol do you use to clear the codes? I updated it in December.
Yes, that one. Auto select, OBD II, and you pick CAN. With an automatic transmission, a window opens with two control units (control unit 1, control unit 2). The first is the engine and the second is the automatic transmission.
The gearbox is a manual. I'll try updating.
Any scanner clears them, but really only through OBD. Even a small Launch Code Reader with 4 buttons.
I also cleared them through OBD, with a KTS and with a Scanmatic.
The MT10 reported no connection over CAN, but Scandoc cleared the codes through OBD.