← Vortex

Vortex Tingo 2012 robotized gearbox slips the clutch

Vortex Tingo · 2012 9 answers Translated from Russian · original

Hello colleagues! I have a Vortex Tingo in the shop after a clutch cover (pressure plate) and clutch disc replacement. Here is the situation: the car pulls away normally and shifts through all the gears. First gear is fine, you can drive with the throttle floored. But after the shift into 2nd gear something strange happens: after lifting off the power and shifting, the revs climb to 2000-2500 with slight clutch disc slip, and a second or two later the engine revs head for the limiter. The clutch touch point is 26 mm, but at the moment the engine goes to the limiter, the requested and actual actuator position are both about 20 mm, i.e. the ECU itself is releasing the clutch. After 3-5 seconds the control unit suddenly commands 26 mm and the car drives normally, even with the throttle floored and no slip, until the shift into the next gear. Then it all repeats. I don't understand the logic. The only thing is that both front ABS wheel speed sensors are faulty, but I don't know whether the systems are linked. The vehicle speed in the gearbox data is taken from the sensor in the gearbox. Adaptations have been done many times.

Answers
O
Owner Mar 04, 2020

Are there any faults in the engine ECU? Is the software stock? This can happen if the robot thinks the engine does not have enough torque. And of course if it sees the actual speed incorrectly.

O
Owner Apr 18, 2020

ESP intervention can't be ruled out.

O
Owner May 02, 2020

There are no faults in either the engine ECU or the robot. The one thing I haven't checked is the software. The actual speed matches the real speed. It just looks strange: at the moment of slipping there is no acceleration at all. I'm not sure about ESP torque compensation, since this car has no ESP. I pulled the whole ABS unit connector out as a test.

O
Owner Jun 07, 2020

Strange. I haven't yet come across a 2012 car without ESP. At least the system should have an anti-wheelspin function. And if it doesn't see even one wheel speed sensor, games like this can start to appear.

O
Owner Jul 08, 2020

I disagree about anti-wheelspin. Its logic always means limiting engine torque, not releasing the clutch and sending the revs to maximum. As for the speed sensors, it's ambiguous: the Opel EasyTronic, for example, relies on the front speed sensors, but it also logs faults for them.

O
Owner Oct 16, 2020

I'll put it this way: I don't know about Asian cars, but on European ones, when there is something wrong with the drive or wheelspin is suspected when pulling away, a snowflake light for the gearbox or a "slippery road" or "attention" triangle or an ESP light usually blinks. Is there anything like that?

O
Owner Apr 06, 2021

To repeat, there is nothing like that. There is no ESP, and the ABS connector was unplugged as a test. I know how stability control and anti-wheelspin work.

O
Owner May 15, 2021

OK. Going by the clutch actuator current: what do the parameters show? Is there any jerking during shifts? Maybe it just sticks a bit and doesn't have time to respond.

O
Owner Jun 26, 2021

No jerking, no crunching, it shifts well. The commanded position matches the desired one. The accumulator pressure is about 40 atm, but that also affects the speed and the amount of clutch release.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →