← BMW

Central locking, windows and interior lighting stopped working on BMW X5 E53 M54

BMW X5 10 answers Translated from Russian · original

Hello everyone, it looks like I've run into trouble and need help. Before taking the engine apart I wanted to check the data. As soon as I connected the scanner, the siren went off, the interior lights went out and the central locking died. It doesn't respond to the key or to the button in the cabin. The power windows are also dead. The scanner is a Bars3. It had connected to cars like this without problems before, and the service had reset things and so on. I had never seen anything like this. The battery was weak and I barely got the car started. I drove it into the bay and shut it off. Then I saw the brake lights were on, and when I switched the ignition on they went out. I connected the charger and the brake lights went off. Then I went into OBD and this problem appeared. The car starts and the siren is not sounding. I haven't tried driving it, as the car is already partly disassembled.

Answers
O
Owner Dec 01, 2019

The body module is under the seat. Check it for errors with Launch. The battery most likely put it into transport mode. There is a 50/50 chance of getting it out of that mode. If that fails, the module has to be replaced. I think the wipers have stopped working too.

O
Owner Dec 06, 2019

I forgot to mention that there is no power at the OBD port and the scanner won't start. I haven't tried an external one. I'll dig into it tomorrow if you can point me where to look.

O
Owner Dec 16, 2019

Check it with Launch first. It has a function for removing transport mode. Not long ago I worked on a bucket of the same year (a Range Rover) with this fault, and most of its modules are from BMW. I also tried to clear it with INPA, with no success. There is also a program called Tool32, and people tried to clear it with that too, also without result.

O
Owner Dec 24, 2019

The brake lights were also on in mine, by the way.

O
Owner Dec 29, 2019

The front wipers and washer really do not work. The rear wiper works. What is the resistance on the OBD2 cover, and does the power to the OBD port also come through the body module? I'm looking in Alldata and can't find it.

O
Owner Feb 08, 2020

Thank you very much! It seems I got away with it. Fuse number 14 had blown when the scanner was connected. It's 5 amps. I replaced it and everything works.

O
Owner Feb 18, 2020

You probably need to check the rear left strut, on the jack again. They lifted it with the jack, it hissed and the air escaped. The compressor keeps blowing, but the strut doesn't rise. In the end there's an error saying it needs a lot of energy for the compressor to inflate the strut. However, it's unclear how this relates to replacing the compressor.

O
Owner Feb 29, 2020

Haven't you pulled off a ground anywhere? The heater motor resistor gets terminal 30 and the control from the climate control unit. I don't remember whether it's PWM or voltage. If the ground is broken, positive can appear on the control wire, which would explain the motor spinning. And if the ground is shared with the airbags, it would also explain the loss of communication with the SRS module.

O
Owner May 07, 2020

That's great ;)

O
Owner May 26, 2020

I once had a glitch exactly like this on a Sorento. While I was digging through the wiring diagrams to check the module's power supply, the customer himself found a blown fuse for the interior lighting. After it was replaced, everything worked. Obviously the cars are different, but the same search direction can be applied...

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →