Honda Stream D17A: timing belt snapped
Someone dragged this little car in, and during diagnosis it turned out the timing belt had snapped. That raises two questions. How much does this job cost (has anyone done it?), and could the valves have bent? The belt snapped at the moment of starting (the car didn't start). Autodata allows 2.7 labor hours for the replacement, but it feels like the job will take a whole day.
Blow air through the cylinders, just in case, to check for bent valves. Replacing the belt is easy. The only problem is the bolt on the crankshaft, which, if I remember correctly, has a left-hand thread. I charged 3 thousand rubles.
If I remember correctly, on almost all Hondas the valves bend when the belt snaps. PS: you can't trust the owner!
From 5 to 8 thousand, and it all depends on your labor, not on how difficult it is for the inexperienced.
After the latest interrogation of the customer, it turned out the belt snapped at a traffic light, at idle. I'll be taking it apart today, thanks for the advice!
I couldn't get the crankshaft bolt off. It's not clear whether it's a left-hand or right-hand thread. I called half the city and everyone says something different. A special wrench is needed to remove it. On Monday I'll go around the workshops, maybe I'll find one. The wrench for removing the bolt needs to be tougher, hardened, and not a domestic one. Sockets break easily!
The thread is right-hand. Lock the shaft by putting a nut with a breaker bar onto the pulley, then put a socket on the bolt through it. You'll need a strong breaker bar. You can easily make the wrench yourself.
I finally put it back together and started it. The valves in cylinders 3 and 4 were bent! Above 1500 rpm it runs fine, but sadly, that's it. Forget it, from now on only diagnostics and no mechanical work.