← Dodge

Dodge Caliber 2.0, 2008. Transmission fault code U1146

Dodge Caliber · 2008 12 answers Translated from Russian · original

VIN 1b3hbg8b97d184788. 2008 2.0 automatic, transmission number 05094620ag, ECU DCA. Question: how do I deal with the error U1146 - lost communication with external memory? If I start the engine without waiting for the self-test to finish, everything is fine and the transmission does not go into limp mode. If I wait for it, the transmission does go into limp mode. The connectors have been cleaned, and the wiring from the transmission to the ECU is intact.

Answers
O
Owner Oct 25, 2020

The first time the engine is started, the transmission control module reads the calibration data from the external EEPROM (located in the transmission) and saves this information in the EEPROM of the automatic transmission controller. If the controller cannot read the external EEPROM, this DTC is set in the automatic transmission ECU. After two consecutive failures, the MIL lamp on the instrument panel comes on. The problem may still be in the wiring (short circuit, poor contact, etc.). The problem may be in the transmission valve body (a faulty valve, so the calibrations do not get through). The ECU may be faulty.

O
Owner Nov 04, 2020

A customer replaced the transmission because of this error. It needs to be checked whether the valve body was replaced.

O
Owner Dec 03, 2020

If the automatic transmission was replaced, the valve body was most likely replaced too, since it is installed inside the transmission.

O
Owner Dec 12, 2020

So I need to look more carefully at the wiring from the transmission to the engine ECU...

O
Owner Dec 26, 2020

I think that is the first thing to do, yes. P.S. Are there any other errors in the automatic transmission besides this one?

O
Owner Jan 14, 2021

For the engine, there is P0700, which is again a transmission error. Is anyone nearby with the pin data for the engine control unit, SIM 90 Siemens? The wiring was checked visually for broken wires (everything is routed together) and with a continuity test. No faults found.

O
Owner Mar 17, 2021

Well, that is a message from the PCM about an error in the TCM. (Sorry for the pun.)

O
Owner Jul 03, 2021

Try resetting the adaptations. And first read the EEPROM from the automatic transmission with an external programmer.

O
Owner Aug 05, 2021

Thanks, but for resetting adaptations I only have an Audi tool.

O
Owner Aug 11, 2021

Read the EEPROM, and you will also see the condition of the ECU. I dealt with this a long time ago.

O
Owner Sep 01, 2021

I'll read it and report back.

O
Owner Sep 07, 2021

Closing the topic! The transmission control unit is located under the driver's feet, so the wiring runs under the left fender and LIES on the protective shield, not insulated from the factory. It has chafing. Thanks everyone.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →