← Toyota

Toyota Prado 120, 2004. Brake pedal sinks to the floor

Toyota Land Cruiser Prado · 2004 8 answers Translated from Russian · original

Hello, diagnosticians. This isn't quite an electrical topic, but I didn't know where else to post it. The problem: a 2004 Prado with an electric brake booster combined with ABS. When braking from highway speed, it stops fine. But when driving in traffic, if I ease off the pedal a little and then press again, it goes lower. After 6-7 such brake applications the pedal is on the floor. What has been replaced: calipers and pads, all of them. The calipers are not original, they are FENOX. The front ones are seized solid on the inner side. The discs are worn, but in my opinion within limits. On the inner side there are visible signs that the pads have not bedded in. The master cylinder was replaced with one from a 150 Prado, because there is no official repair kit and this one fits exactly. The brake fluid is original; I bled the system several times with a Touchstream. I'm sure there is no air. There are no errors in the system. The pump works. Where should I dig next? Does anyone have solid information on how this system works?

Answers
O
Owner Feb 24, 2020

Only the complete hydraulic unit. Roughly 50-80 thousand rubles. A unit from a dismantler is not recommended. It's the brakes, after all.

O
Owner Feb 27, 2020

There is a belief that the hydraulic unit can be repaired. I haven't managed it myself.

O
Owner Mar 04, 2020

I wouldn't want to break it completely. I'm interested in how this system works. Is there a self-learning (adaptation) manual like the ones for VAG?

O
Owner Mar 15, 2020

That's a Toyota hassle. They don't have things like that. You can try to repair it. But who will be left to sit in it afterwards?

O
Owner May 11, 2020

That's a rather debatable point. Cars with under a hundred thousand of mileage often end up at dismantlers. And if the choice is between a new part for 100 thousand and a used one for 10 thousand, the choice is obvious.

O
Owner May 15, 2020

How is the hydraulic accumulator built? What's inside? Just a spring with a diaphragm?

O
Owner Jun 06, 2020

I've never seen the accumulator itself fail. With age it's the brushes, the rotor commutator and the winding.

Autopapyrus assistant AI assistant Sep 14, 2026

You wrote the key detail yourself: the front FENOX calipers are "seized solid on the inner side." A seized piston doesn't fully return after the brake is pressed. Fluid stays in the caliper, and on the next application there isn't enough of it. That explains the pedal sinking in traffic, where there is frequent light braking. Before spending 50-80 thousand on the hydraulic unit, take the front calipers apart: if the pistons don't move freely, that's the cause. Seized new parts are typical of non-original parts.

Step-by-step details: https://www.autopapyrus.ru/guides/renault/talisman/i-pokolenie/2016-present/-/kak-ustranit-skrip-pedali-tormoza

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →