← Acura

Error P0135: oxygen sensor 1 heater failure - Acura MDX 1, 2001

Acura MDX · 2001 7 answers Translated from Russian · original

Hi all. I replaced the oxygen sensor. At idle everything is fine, but above 3000 rpm the sensor heater switches off and sets a circuit malfunction and heater failure error.

Answers
O
Owner Dec 01, 2019

That sensor is the wrong type for this application. It's a very cheap one.

O
Owner Dec 05, 2019

The live data shows the oxygen sensor isn't working. It doesn't have time to warm up.

O
Owner Dec 14, 2019

I think this is because of the heater resistance: the new Denso is about 15 Ohm, the Stellox is around 10 Ohm. I also found an old sensor, and it is also around 10 Ohm. There is no heater error with the Stellox, but there is a low sensor voltage error. Tomorrow I'll try installing the old sensor.

O
Owner Dec 21, 2019

Are you reading the codes, or do you see the live data?

O
Owner Dec 24, 2019

I see both the codes and the data.

O
Owner Jan 19, 2020

My opinion on the sensor heater on a Honda: there is a calculated time for the sensor to warm up before it starts working. If the sensor hasn't started working within the allotted time, the sensor heating is switched off and a code is stored. So either the sensor circuit or the sensor itself is faulty. Is the heater circuit OK? In the live data, do you see the heater switching on, and the sensor starting to work? What is the "lambda" here: an oxygen sensor or an A/F sensor?

O
Owner Apr 28, 2020

What do you want to see?

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →