← Saab

Saab 9-3 won't start until you remove the battery terminal

Saab 9-3 9 answers Translated from Russian · original

My Saab stalls in hot weather. It won't start until you disconnect the battery terminal. Error P0601. I'm worn out.

Answers
O
Owner Mar 10, 2020

Yes, it's a T8. Part number 55565020. Saab 9-3 2007 facelift, 2.0 manual, 150 hp.

O
Owner Mar 24, 2020

The Saab engine ECU sits in a poor location and overheats. By around 250,000 km the unit simply fails. Before that, faults are diagnosed in the circuits of all the injectors, and the engine jerks, runs on three cylinders, stalls and puts out light-colored smoke from the exhaust pipe. The engine control unit can't be repaired. You have to buy a new or used one and reprogram it before installing it.

O
Owner Apr 15, 2020

I know it's a known weakness. One thing bothers me: the ECU was moved by previous owners. It now sits in the passenger footwell. Before that, the car complained about the intake air temperature sensor, which was known to be good. A break was found where the wiring harness had been spliced, near the ECU. After that the car came out of limp mode and drove the way a Saab should. So now I'm worried that I'll buy an ECU, install it, and the same problem will come back. I've read on forums that reprogramming helped people with the same trouble. But that needs a GM MDI, and there isn't one anywhere near us. Also, the official dealer's tech tool reads my car poorly. It sees the SID's errors but not the ECU's errors.

O
Owner May 15, 2020

Are the 5 V sensors normal at that moment? Does it react when heated with a hair dryer? Does the diagnostic connection drop out at the moment the engine stops?

O
Owner Jun 09, 2020

I'll check the 5 V. An ELM reads the car after that and sees only one error. In winter it only showed up when the heater had been running for an hour in the car, or if warm air was directed to the footwell, which is where the ECU is. Now the car can sit in the sun for half a day and then stall after driving 200 m.

O
Owner Jul 09, 2020

You could measure the ECU housing temperature at which the problems start. Then, on a cold car, heat the ECU to the same temperature and see what happens and whether P0601 appears.

O
Owner Aug 16, 2020

The ECU was definitely opened before. A small hole in the housing wasn't plugged with the sealing rubber. I'll try measuring. Do you suspect that a single component is overheating? Or that at a certain temperature it sends a command somewhere and gets a refusal or a short circuit? With the A/C blowing into the footwell, the problem still repeats.

O
Owner Oct 12, 2020

The problem is the am29bl802 in the unit.

O
Owner Dec 21, 2020

So the flash chip reacts like this to heat? Does it make sense to try reprogramming through a GM MDI? Or replace it, or resolder it? Should I read the original off it first, or can I load a custom file onto a blank one?

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →