← Luxgen

Luxgen 7 2.2 Turbo runs poorly above 2500 rpm

Luxgen 7 10 answers Translated from Russian · original

Colleagues, I'm asking for help from the collective mind. What we have: 1) I only looked the car over superficially, took a short drive and formed a general impression; there was no time. 2) The car won't pull above 2.5k rpm. No receipts or service records. The fuel filter has been replaced. 3) At idle with no load, the revs climb up to 4 (that's the limiter, it won't go any higher). 4) While driving it feels as if the turbo cuts out. Above 2,500 it won't pull. If you lift off the throttle and press it again, it blows a bit, the revs rise and then the pull drops off again. 5) In manual mode the revs barely climb and there is almost no pull above 2.5. 6) There is a strange ringing noise in the exhaust system when revving. It seems to be located close to the engine. 7) Stall test reaches only 2.5 (full throttle with the brake held on the automatic transmission; it should be 2.8-2.9). Share your thoughts on which parameters to check when it arrives, so I don't waste time on this beast. My first thought, judging by the strange noise, is a problem with the catalytic converter after the turbo. The exhaust can't get out, so the turbo doesn't spin up.

Answers
O
Owner Jun 14, 2020

Measure the exhaust back pressure. The exhaust may be clogged.

O
Owner Jul 22, 2020

The catalytic converter has 100% fallen apart.

O
Owner Sep 30, 2020

You could unscrew the first lambda sensor and go for a drive.

O
Owner Jan 25, 2021

Check the fuel pump flow rate.

O
Owner Feb 10, 2021

Thanks, colleagues. The overall picture is clear. First we'll try letting the exhaust breathe, then we'll look at the fuel. I'll post the results when I have them.

O
Owner Dec 28, 2021

I would also do a smoke test and check the turbo control unit for leaks and air-tightness.

O
Owner Jan 17, 2022

It's as simple as it gets. There's a mechanical bypass that relieves the excess pressure at 0.6-0.7, and there's no other turbo control. We checked the valve with a pressure gauge. For some reason it was set to 1.1 from the factory. We adjusted it properly, the gate opens and the excess pressure is released, but it didn't get any better.

O
Owner May 05, 2022

On VW there's a throttle flap on the intake. It's a weak spot on all TDI engines.

O
Owner Jul 22, 2022

Is it a diesel?

O
Owner Aug 16, 2022

No, I wrote too much. Usually there's another intake flap on turbo engines, but not on all of them. I'll stay quiet until I verify the information.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →