← Mercedes-Benz

Mercedes-Benz Sprinter Classic - Check engine light, ABS light, speedometer not working and loss of power

Mercedes-Benz Sprinter 9 answers Translated from Russian · original

A regular customer asked me to look at a minibus. I'll say up front that I mostly repair construction equipment, and I simply don't know newer cars, especially European ones. Calling a Mercedes specialist isn't an option: the vehicle is in Yuzhno-Kurilsk, and more than half of them don't even know where that is. What I have checked: 1. The wiring from the control unit to the sensors is fine. 2. I couldn't measure the sensors. They read as an open circuit, and that's true of both the new and the old ones. 12 volts goes to the white wires of the sensors, and even the warning lamp is on. The sensor has two wires. I'm used to the idea that if a sensor has two wires, it has resistance and, as a rule, one end sits on ground, while from the other end you get a sine wave of about 2 volts when the wheel turns. But here everything is different. Please help me figure it out.

Answers
O
Owner Dec 01, 2019

Checking ABS sensors: MRE sensor

O
Owner Dec 06, 2019

Thanks, that explains a lot.

O
Owner Dec 12, 2019

I've more or less figured it out. I replaced the front left sensor and the speedometer started working. I disconnected the rear brake pad sensors, and the check engine light and the wheel light went out. The van drives now, but about once a second a buzzer sounds. The ABS light still hasn't gone out. The SRS lamp also comes on and goes off, and then the handbrake lamp with an exclamation mark inside comes on right away. Please tell me what to look at, so that at least the buzzer stops beeping.

O
Owner Dec 16, 2019

You just disconnected them and that's it?

O
Owner Dec 21, 2019

I should have checked which lamps would go out. New pads have been ordered. Or did the pad service also need to be reset somehow?

O
Owner Dec 29, 2019

You can check the brake fluid level. But without reading the fault codes it's hard to say anything here.

O
Owner Feb 05, 2020

An oscilloscope on the heater control and on the power supply might show something interesting...

O
Owner Feb 15, 2020

The problem is that the scanner I have won't communicate with anything except the engine.

O
Owner Feb 23, 2020

After reading up on the internet a bit, I have a question: who would take on reflashing the computer to remove the particulate filter, and so on? You can message me privately.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →