← Chrysler

Chrysler Voyager 2002 2.4L automatic: transmission won't shift up

Chrysler Voyager · 2002 9 answers Translated from Russian · original

Chrysler Voyager 2002, 2.4L, automatic transmission (US-market car). The transmission won't shift into a higher gear. Transmission type EATX-41E, TCM part #: 04727530AA. The transmission has a stored code P0755, 2-4 Shift Solenoid Circuit. How can I test it? I suspect the wiring. I need a wiring diagram for the actuators. If anyone has an Alldata subscription, please take a look (the American data is well detailed there). Something else caught my attention during transmission diagnostics: the oil temperature is stuck at -18°C and the cold transmission flag is set. The transmission has two two-wire sensors. I disconnected them, but the readings don't change. Thanks.

Answers
O
Owner Jun 14, 2021

Check the resistance of this solenoid and compare it with the other identical solenoids. If you don't know what it should be, then as a last resort swap the solenoids around, if they are the same ones used for the other gears. Tap into the connector and watch the control signal when the shift should happen. The wiring to the ECU is as simple as it gets. You can check it without a diagram. As for the temperature sensor, it looks like there is a problem. Maybe you disconnected the wrong sensor, which is why the temperature reading didn't change. Start with that sensor.

O
Owner Jun 21, 2021

That's the problem: finding where the solenoid is and which of the two sensors is the temperature one. :) The transmission has a large connector with 4 pairs of wires, held by an 8 mm bolt, and two two-wire sensors. I need at least a simple diagram or a drawing.

O
Owner Jul 01, 2021

I downloaded the documentation and now it's all becoming clear. The two two-wire sensors are the transmission input and output speed sensors. The 8-pin connector is for the solenoids. The 2-4 solenoid is on pin 8.

O
Owner Jul 14, 2021

So it really is on pin 8. And? Is the solenoid open-circuit?

O
Owner Aug 14, 2021

Calm down, just calm down. The car was initially diagnosed and sent off. Now I'm digging up information and getting up to speed. :)

O
Owner Sep 07, 2021

What information are you digging up? You wrote that you found everything. Mitchell says: check the connector, check the wire from pin 8 on the transmission to pin 19 on the ECU, and check the solenoid itself for an open circuit. That's all it says.

O
Owner Oct 07, 2021

Report: the solenoid has an open circuit, the temperature sensor tests fine, and all the wiring is fine. Does anyone know if it's possible to replace just one solenoid? The manuals say to replace the whole solenoid block.

O
Owner Nov 01, 2021

Yesterday I replaced the whole solenoid block and the car drove off without any problems. Sometimes parts take this long to arrive.

Autopapyrus assistant AI assistant Sep 25, 2026

Note that the question about the oil temperature sensor (constantly -18°C) was left unresolved. On this transmission the ATF temperature sensor is usually built into the solenoid block, so the temperature reading problem should have gone away after the block was replaced. If the symptom remains, check the wiring to the TCM and the transmission control module itself. Incorrect temperature readings can cause delayed shifts when cold and harsh shifts, because the TCM uses this data to adapt pressure.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →