Ssang Yong Kyron 2.3 - stalls with no symptoms
Kyron 2.3 (G23D; M161.970), automatic transmission, 2009, Siemens VDO HM 2.3L 4cyl A161 545 87 32. After a year of ownership (in my hands) the following problem has appeared. It runs without problems, the corrections and all parameters are normal. Once or twice a month it stalls while driving, after a relatively long drive. We drive, it stalls on the move, and when I try to start it, it barely catches (as if there is no fuel), then it no longer catches at all. We wait 20-30 minutes, then it starts easily, and we drive without incident for about two weeks. It is very hard to catch the moment. I ran it for 2 hours in the shop with the A/C and other consumers on, and there was no fault. Knowing the crankshaft sensor problem on Mercedes-Benz, I went and bought one. I drove about two weeks, and the same fault came back. At the moment of the fault, right after it stalls, when I try to start it the scan tool sees starter cranking RPM. It sees the ignition angle. Later, once it has cooled to 50-60 degrees, the scan tool sees cranking RPM, but it won't start. We wait longer, and it starts easily, and we drive for two weeks. Of course there is fuel in the rail, and the scan tool parameters, vacuum and so on are visible. I couldn't check for spark. All the wiring harnesses have been wiggled and checked (in normal modes with an oscilloscope, practically all signals), and nothing looks suspicious. I carried the laptop with the oscilloscope around for about two weeks, then gave up. As soon as I gave up, the fault appeared. The reason I'm asking: I can't reproduce the fault in the shop, and when it stalls I usually have nothing at hand. Are there typical faults of this kind? For example, on the MUSSO 2.3 the ceramic module, the assembly responsible for ignition, was a weak point (I don't remember exactly), though usually one coil for two spark plugs would drop out. I opened up the ECU and found no ceramic module. Of course there are no fault codes on the scan tool.
Try another control unit and drive with it. I think buying one from a dismantler isn't a problem.
2-3 weeks? There's the immobilizer, which means pairing and unpairing (I'd have to do it myself, I don't have the equipment). I want to find it by a "scientific" method. It looks like I'll have to keep driving around with the oscilloscope.
You need to work out what is missing at the moment it won't start.
Sorry. I wrote the post before I opened up the ECU. I thought there was the same "ceramic module" in there, and that's what I suspected. I just never get around to working on my own car. Now I'll make some test lights for the injectors and for the coils. Since the scan tool sees RPM and ignition angle, the crankshaft side must be fine.
It looks more like the camshaft sensor. There's no problem pairing another ECU to this car: just read the full dump from your own unit and write that dump to the new, used or other unit.
I don't go near any full dumps (you can't cover everything), because repair is usually enough (a sensor, wrong readings and so on). Thanks for the attention to the problem (the post). (Also, I gave few details: in a year and a half I've only opened the hood to change the oil filter and top up the washer fluid.) I'll report back with the results.
By the way, it starts without the distributor (camshaft sensor) with no fault. At the moment of the fault I unplugged the distributor sensor, and it still wouldn't start.