A8 2004: cannot connect to any control module
Problem: Address 01: Engine Electronics – cannot be reached. How can I reach the module? Also, on the car with the ignition on but the engine not running, I cannot connect to any module, and the engine module will not connect in any case. Car: AUDI A8 (4E) 2004. VIN: WAUZZZ4E73N006163
What are you using to try to reach it?
And it is best to reach it over the CAN bus.
VAG-RUS should be able to reach it. Look for communication problems between the modules, check the integrity of the diagnostic lines, and look in the gateway; there should be inter-module communication errors.
Thanks, maybe that is why there is no connection with the adapter when the ignition is on.
What do the other modules complain about (02 and 03 especially)?
First, disconnect the ABS module; then it may be possible to get to diagnostics on the engine control module. Judging by the neighboring thread, the ABS module needs replacing; the error speaks for itself. One of the conditions for it is a voltage drop when the ignition is switched on. The factory recommends connecting a battery charger during any work that requires the ignition to be on.
02 has no errors, and 03 has error 014 - out of adaptation range, above the upper limit (at idle). A couple of days ago the ABS module was not showing a single error, but the engine module still would not communicate. I will go and try disconnecting it now.
That is something new. You will not get much done in VAG-RUS 9 with a translation like that. In module 03 you have error 00003, control module, status 014, malfunction.
It is not VAG-RUS? I downloaded the fault codes from a forum. Today I will post the full picture of the faults on this car, maybe someone can suggest something.