← Infiniti

Infiniti FX50 S 2008: can't perform idle air volume learning

Infiniti Fx · 2008 10 answers Translated from Russian · original

I cleaned both throttle bodies and the injectors, and after that I can't complete the learning procedure, either with Consult or with the tap method. The revs don't drop below 2000. There are no vacuum leaks anywhere. I've tried every available method with zero result, my brain is boiling. Has anyone had something similar and found a cure?

Answers
O
Owner May 31, 2021

The tap method should work. Use a stopwatch. Or something is preventing it, for example the MAF sensor is out of normal limits. The engine isn't warmed up, or something else. As a last resort, remove the ECU and try discharging the capacitors. That fully clears the learned values.

O
Owner Jun 13, 2021

Try starting the learning on the scanner and putting it in D. When the revs start dropping, put it in park.

O
Owner Jun 22, 2021

Were the injectors by any chance cleaned in an ultrasonic bath?

O
Owner Jul 08, 2021

Yes, that's the only way they do it.

O
Owner Jul 26, 2021

The O-rings on the injectors could have been pinched or torn.

O
Owner Oct 01, 2021

In the end, they decided not to remove the engine control unit, let alone open it. They left the car for a day without the battery, and we'll see after that.

O
Owner Nov 11, 2021

I had the same problem. I plugged all the openings in the intake manifold from the crankcase ventilation and started the learning procedure. I also switched the region to America.

O
Owner Nov 22, 2021

How did you solve the problem? I have a G35 and an FX50, both with two throttle bodies. On the G35, CS Lite with the 1060 throttle couldn't do the learning and shows nonsense, with revs of 38000. Work Support only has this, and even that doesn't work. I haven't tried the tap method, but I strongly doubt it exists there. Does anyone know if this was fixed in the new version of Carman?

O
Owner Dec 17, 2021

There are usually no problems with the 35, but the 50 wasn't fixed even in Moscow. They said the ECU needed replacing. So I pulled the EEPROM from the ECU and, by trial and error, since there is no information at all, told the unit that it was new.

O
Owner Sep 08, 2022

In general, cars from these years are already self-adapting. As the engine warms up, the revs settle at the nominal value, provided there are no externally introduced problems. The manual method doesn't work. Carman is complete rubbish. But if the learning procedure is still available in Consult, then while running the procedure you need to put the car into a fault (limp) mode by disconnecting the MAF sensor or the throttle bodies. After clearing the codes and the angle and MAF corrections, the revs will drop and fall within the range Consult can capture. Then you'll be able to do the learning in normal mode.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →