Jeep Cherokee 1993 4.0L: spark disappears when the engine warms up
Urgent help needed with a wiring diagram. The car belongs to a vacationer who has to leave on September 5. Jeep Cherokee, 1993, 4.0L, 6 cylinders, distributor, VIN: 1J4FJ28SOPL590325. Once it warms up, the spark disappears. The fuel pump gives 3 atm without vacuum and 2.3 atm with the vacuum line connected. The injectors open normally. But there is no spark when hot. When cold it runs smoothly, then as it warms up the engine starts to run roughly, the spark is delivered only every other time, and in the end the engine stalls. Three wires come out of the distributor: ground, positive (oddly, 9.5 V) and a square wave about five volts peak to peak. These readings do not change either hot or cold. My questions: 1. Does anyone have a diagram of the ignition system? I want to know where the ignition module is, inside the ECU or as a separate unit. I couldn't find anything like a module near the distributor and coil. 2. Why is the Hall sensor supplied with 9.5 V and not 12 V, for example, or is that a feature of this car? 3. During the repair I tried feeding five volts from a generator in place of the Hall sensor output, and it didn't work. The engine did not react at all, either cold or hot. Why is that? It works fine on other cars. That's all for now. I really need an ignition system diagram for this car. Please help with a diagram.
Check your private messages. I sent you the information.
If you don't find it by tomorrow, I'll send it from Mitchell.
I can't open it, it says Error, the link doesn't work. Could you copy the link again? Please send it. Whether I find it or not, extra information never hurts.
Take a look, I put some links and information in your private messages, maybe it will help.
The ignition module is inside the ECU. Open it up and replace the three 220 µF 25 V electrolytic capacitors. Find the coil control switch, which you can check with a continuity tester, and replace it with a switch from a Zhiguli (VAZ). I made a separate heat sink for it. I built it with surface wiring and drove it like that. I can take a photo of the ECU, they are here for repair. With the engine running you can disconnect the distributor and it will keep running until you shut it off. Once it is shut off, it won't start again and there will be an error. You can read the codes with the ignition key, and there is a description of the codes on Avtograd.
Thanks everyone for your help. I'm now drawing some conclusions for tomorrow's work. According to the diagrams provided, the car has a crankshaft position sensor (CKP), and that sensor is powered with 8 V. Now it is clear why the Hall sensor gets 9 V and not 12 V: it is fed from the same 8 V source (slightly high). The Hall sensor in the distributor is the camshaft position sensor (CMP), so now it is clear why the car did not react to the pulses from the generator. Tomorrow I will check the CKP signal, then the operation of the ignition module inside the ECU, and I think that will end the repair saga with this car. After the car starts successfully, I will definitely
I sorted out the problem. The fault was in the CKP sensor (the green trace). When cold everything looks fine, but when it warms up this kind of garbage starts to appear. Many thanks to everyone for the help. The thread can be closed.