Autopapyrus · Bentley Continental Flying Spur 4.0 V8 (2017)
https://autopapyrus.com/catalog/bentley/continental-flying-spur/guides/ignition-coil-replacement/
https://autopapyrus.com/catalog/bentley/continental-flying-spur/guides/ignition-coil-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Bentley Continental Flying Spur 4.0 V8 (2017): Ignition Coil Replacement
The 4.0 V8 TFSI engine (EA824) uses a coil-on-plug configuration, with one coil for each of the eight cylinders. Scheduled replacement of the coils and spark plugs is every 40,000-50,000 km or every 4-5 years. Misfires are most often caused by a failed coil. It is recommended to replace all eight coils at the same time to avoid repeat failures.
Part
| № | Part |
|---|---|
| 01 | Ignition coilset of 8Find on Amazon → |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
6Step by step
10 steps- Open the hood and disconnect the negative battery terminal. Remove the decorative engine cover (clips around the perimeter).
- Remove the airboxes on both sides of the engine by undoing the screws and releasing the clips. Remove the frame braces above the airboxes.
- The coils become accessible after the upper intake components are removed. Clear the space above the cylinder banks.
- For each coil: disconnect the electrical connector (latch on the side) and remove the Torx T30 mounting screw.
- Carefully pull the coil straight up. It sits in the spark plug well. If the coil is stuck, use a plastic trim pry tool to separate it from the seal. Do not pry with a metal tool.
- Remove the old coil and inspect the plug well and the spark plug contact for oil, carbon deposits or cracks.
- Insert the new coil into the spark plug well until it is fully seated (you should hear a distinct click as it locks). Tighten the mounting screw to 6-9 N·m (4.4-6.6 lb-ft). The exact value depends on the engine variant, so follow the manufacturer's specification.
- Connect the electrical connector until it clicks. Repeat for the remaining seven coils.
- Reassemble the airboxes, frame braces and decorative cover in reverse order. Reconnect the battery terminal.
- Start the engine and check for misfires and vibration. If the Check Engine light is on, read the fault codes and, if necessary, clear the memory after a successful start.
Common mistakes and warnings
- The 4.0 V8 TFSI engine is built on the Audi EA824 platform and was used in the Audi S6, S7, S8, Porsche Panamera and Cayenne, so some parts are interchangeable
- If you find oil in a spark plug well, check the condition of the valve cover and the spark plug well seals, because oil shortens coil life
- Replacing all eight coils and the spark plugs together is recommended to avoid repeat trips to the repair shop
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of Bentley
The company dates back to 1919. It was founded by engineer Walter Owen Bentley, who had been passionate about…
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →