← Trooper Isuzu Trooper repair manuals →

Isuzu Trooper (1st Generation): Ignition Coil Replacement

On a 1989 first-generation Isuzu Trooper, the ignition coil is part of the breakerless distributor-based ignition system. Replace it if there is no spark or the engine misfires. The procedure is simple: two mounting points, two power terminals and one high-voltage wire.

DifficultyEasy Time20-30 minutes Steps10

Part

№PartAlternatives
01 Ignition coilFind on Amazon → AlternativesNGKAccelCarquest

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

2
There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes and 1 more. See manuals →

Step by step

10 steps
  1. Disconnect the negative terminal from the battery.
  2. Label the high-voltage wire running from the coil to the distributor (the thick center wire).
  3. Disconnect the coil power connector (two terminals: positive and negative).
  4. Disconnect the high-voltage wire from the coil's center terminal.
  5. Remove the two mounting screws or bolts. The coil is usually mounted on a bracket near the distributor or on the valve cover.
  6. Remove the old coil.
  7. Install the new coil and tighten the fasteners to 20-27 N·m (15-20 lb-ft). This is an approximate value; check the manufacturer's service manual for the exact specification.
  8. Reconnect the power connector, observing polarity: positive to positive, negative to negative.
  9. Connect the high-voltage wire to the coil's center terminal.
  10. Reconnect the negative battery terminal, start the engine and check that it runs properly.

Common mistakes and warnings

  • Before installing the new coil, you can test the old one with a multimeter
  • The primary winding resistance (between the positive and negative terminals) should be 1.1-1.5 ohms
  • If the reading differs significantly or the circuit is open, the coil is faulty
  • Do not mix up the positive and negative terminals when connecting the coil, as this will damage it
Spotted a mistake? Tell us →