← Granta

Lada Granta 1.6 8V VAZ-11186 (2018): Fuel Filter Replacement

The Granta's fuel filter is located under the rear of the body, near the fuel tank, to the right of the rear wheel. The filter has a metal housing and sits in a plastic clamp holder, with the hoses pushed onto latching fittings. The manufacturer recommends replacing it every 30,000 km; replace it a bit more often if the gasoline quality is poor. Signs of clogging: jerking while driving (first at high rpm, then at low rpm) and increased fuel pump noise. No fasteners need to be unscrewed, so no torque specs are needed.

DifficultyEasy Time30-40 minutes Steps17

Key figures

  • Filter replacement intervalthe manufacturer's recommendation; replace sooner if the gasoline is poor (whole job)
    every 30,000 km
  • Fuel pump fuseremoved in step 2 to relieve pressure so gasoline doesn't spray out when the hoses are disconnected
    F21, 15 A
  • Arrow on the filterthe fuel flow direction; it must not be reversed when installing in step 12
    points toward the front of the car

Check these values against the manufacturer’s specification for your vehicle before you start.

Diagram: where the fuel filter is and how it is held

View from below, rear, right of the rear wheelFLOWFront of the car →View from below: the filter sits on the tank, lines connect on both sides1Fuel filter2Plastic holder clamp3Supply line with latch4Outlet line with latch5Flow arrow6Fuel tankTap to enlarge
  1. 1Fuel filter in a metal housing: replace it, pull the old one down out of the clamp.
  2. 2Plastic holder clamp: pull the filter down out of it with some force, push the new one in until it locks.
  3. 3Supply line with latch: press the latch clips with your fingers and pull the tip off the fitting, wiggle slightly if tight.
  4. 4Outlet line with latch: remove the tip the same way, then push on until it clicks and tug by hand.
  5. 5Flow arrow on the housing: must point toward the front of the car when installed.
  6. 6Fuel tank: landmark, the filter sits by the tank to the right of the rear wheel.

Part

№PartAlternatives
01 Fine fuel filter for fuel-injected VAZ (Lada Granta), metal housing, two quick-release fittings1 pc.Find on Amazon → AlternativesBoschSakuraNevsky Filter

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

7

Step by step

17 steps · 4 stages
Stage 1 of 4 Preparation and pressure relief 5 steps
  1. Park the car on a level surface, shut off the engine, and let the exhaust system cool down. No open flames or smoking nearby.
  2. Open the fuse box cover inside the cabin (to the left of the steering column, on the end of the dashboard). Remove the fuel pump module power fuse, F21 (15 A) (check the labels on the box cover).
  3. Start the engine and let it run until it stalls on its own after using up the fuel in the line. Turn the ignition off.
  4. Put the fuse back only after replacing the filter (see step 14). Leave it out for now so the fuel pump can't switch on accidentally.
  5. A small amount of gasoline will remain in the line. This is normal. Keep it away from hot parts.
Stage 2 of 4 Access and removal 6 steps
  1. Drive the car onto a pit or ramp, or raise the rear end and set it on jack stands. Find the filter near the tank, to the right of the rear wheel.
  2. Thoroughly wipe the filter and the ends of the fuel lines next to it with a rag so dirt doesn't get into the fuel line.
  3. Place a small, wide container under the filter to catch leftover gasoline.
  4. Press the latch clips with your fingers and at the same time pull the supply line end off the filter fitting. If it is stiff, wiggle the end gently from side to side. Don't force it with a screwdriver, as you could break the latch.
  5. Remove the end of the return (outlet) line from the second fitting in the same way.
  6. Pull the filter downward with some force to release it from the plastic clamp holder.
Stage 3 of 4 Installing the new filter 2 steps
  1. Compare the new filter with the old one: the fittings and size must match. Find the fuel flow direction arrow on the housing. When installed, it must point toward the front of the car.
  2. Push the filter into the clamp holder until it locks, then push the line ends onto the fittings until they click (the click means they are seated correctly). Tug on each line end by hand to make sure it doesn't come off.
Stage 4 of 4 Checking 4 steps
  1. Reinstall the F21 fuse and close the fuse box cover.
  2. Turn the ignition on for 2-3 seconds (the fuel pump will build pressure), turn it off, and repeat 2-3 times. Inspect the filter fittings for leaks and the smell of gasoline.
  3. Start the engine, let it idle, and inspect the connections again. Starting may take slightly longer than usual. This is normal.
  4. Take a test drive: the jerking and hesitation should be gone. Dispose of the old filter and the gasoline-soaked rags as fuel-contaminated waste. Do not put them in the regular trash.

Common mistakes and warnings

  • Gasoline is highly flammable: work away from flames and sparks, don't smoke, and keep a fire extinguisher nearby
  • Fix any leak at the fittings after reassembly before driving
  • If a fitting or latch breaks during removal, replace the whole line end
  • Do not secure it with a clamp
Spotted a mistake? Tell us →