← Actros

Mercedes-Benz Actros OM471 12.8 (2021): Air Filter Replacement

The OM471 air filter is a replaceable element in a plastic housing. The housing has a cover held by latches or a clamp, plus a restriction indicator (clogged-filter sensor). Trucks from 2021 belong to the MP4–MP5 generation, and the housing design is generally the same. Replace the element based on mileage and when the indicator signals. Check the exact interval and housing configuration against your truck's maintenance schedule.

DifficultyEasy Time20-40 minutes Steps14

Parts

2
№PartAlternatives
01 Primary air filter element for Mercedes-Benz Actros MP4/MP5 (OM471)Find on Amazon → AlternativesMann-FilterDonaldsonFiltron
02 Safety (secondary) air filter elementif fitted in the housing, replace together with the primary elementFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

4
  • Screwdriver or socket for the duct clamp (size depends on your configuration) Amazon →
  • dry lint-free cloth Amazon →
  • gloves Amazon →
  • low-pressure compressed air (only for blowing out the housing, not the element) Amazon →

Step by step

14 steps
  1. Park the truck on level ground, set the parking brake, shut off the engine, let it cool down, and place wheel chocks.
  2. If the filter housing is located under or behind the cab, tilt the cab or open the service cover, as appropriate for your configuration. Tilt the cab only according to the instructions, and make sure it is securely locked.
  3. Wipe the outside of the housing and the area around the cover: dirt must not get into the intake tract.
  4. Disconnect the restriction sensor connector if it gets in the way of removing the cover. Release the connector from its lock first, and do not pull on the wire.
  5. Unlatch the clips or loosen the clamp around the cover's perimeter. Remove the cover and set it aside.
  6. Carefully pull out the primary element without shaking or knocking it, so dust does not fall into the clean side. Note how the element was oriented.
  7. If the housing has a safety element, replace it together with the primary element. Do not leave the old safety element in place.
  8. Wipe the inside of the housing and cover, the sealing surface, and the duct with a damp lint-free cloth. The cloth must not leave lint behind. Make sure no debris falls into the duct leading to the turbocharger.
  9. Inspect the rubber seal on the new element. Compare its size and shape with the old one. Do not lubricate the seal.
  10. Install the new element straight into the housing until it stops. It must seat around the entire seal ring without tilting.
  11. Close the cover, make sure the seal is not pinched, and latch all the clips or tighten the clamp. Use the manufacturer's specified clamp torque, and do not overtighten the plastic housing.
  12. Reconnect the restriction sensor connector. If the instrument panel or the housing indicator has a signal reset, reset it according to the instructions.
  13. Check the air ducts from the housing to the turbocharger: clamps are tight, ducts are not cracked, and there are no leaks letting unfiltered air in.
  14. Start the engine, listen to it at idle, and make sure there are no unusual noises. No intake-related faults should appear on the instrument panel.

Common mistakes and warnings

  • Do not start the engine with the element removed or the cover open: any dust in the turbocharger will quickly destroy it
  • Do not blow out the paper element with compressed air or reuse it: this damages the material and reduces filtration
  • Tilting the cab is a safety-critical job: do it only according to the instructions and with the cab locked
  • If you lack experience, leave this part to a repair shop
Spotted a mistake? Tell us →