← Almera Nissan Almera repair manuals →

Nissan Almera (2005, N16): Replacing the Trunk Light Bulb

The trunk light is mounted on the side of the cargo area, on the shelf. The bulb is replaced by simply removing the lens, and almost no tools are needed. If the new bulb does not light either, the cause is usually the trunk lid latch switch, the light's contacts, or the interior lighting circuit fuse.

DifficultyEasy Time10 minutes Steps13

Part

№PartAlternatives
01 W3W bulb (3 W, wedge-base)1 pc., a spare is usefulFind on Amazon → AlternativesOsramPhilipsNarva

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

2
  • Flat-blade screwdriver with the tip wrapped in electrical tape (or a plastic trim tool) Amazon →
  • soft cloth Amazon →
There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes and 3 more. See manuals →

Step by step

13 steps · 4 stages
Stage 1 of 4 Preparation 3 steps
  1. Turn off the ignition and all electrical loads. Let the old bulb cool down: it may be hot if the trunk lid has been open for a long time.
  2. Open the trunk lid and confirm the light is really not working: set the light's switch (if equipped) to the "on" or "door" position.
  3. Locate the light on the shelf at the side of the cargo area. It is small and sits on a plastic panel.
Stage 2 of 4 Removing the light 3 steps
  1. Pry up the edge of the lens at the slot or notch. Wrap the screwdriver tip in electrical tape so you don't scratch the plastic.
  2. Open the lens and set it aside. Then carefully pull the light housing itself out of its seat if the bulb can't be reached otherwise.
  3. Pull the old bulb out of the contact plates, pulling straight out without tilting it.
Stage 3 of 4 Installation 4 steps
  1. Inspect the contact plates: if they are oxidized, clean them with fine sandpaper and wipe them down.
  2. Push the new W3W bulb in all the way between the contacts. Hold the bulb with a cloth or tissue and do not touch the glass with your fingers.
  3. Close the trunk lid for a second and check that the light goes out, then open it again. The light should come on.
  4. Install the light housing and snap the lens on until you hear a click.
Stage 4 of 4 Checking if the light still doesn't work 3 steps
  1. Check whether the other interior lights work. If they don't, check the interior lighting circuit fuse using the diagram on the fuse box cover inside the cabin.
  2. If the bulb is good but there is still no light, check the switch on the trunk lid latch: it should close when the lid is opened. Also check the condition of the wiring in the corrugated sleeve near the lid.
  3. If the bulb burns out again after replacement, look for the cause in oxidized contacts or a short in the wiring, not in the bulb.

Common mistakes and warnings

  • You don't need to disconnect the battery before replacing the bulb, but do not touch the contacts with a screwdriver while also touching the car body ground with the circuit powered
  • Pry up the brittle plastic lens gently, without force: the clips break easily
  • No tightening torque is needed, as the light is held by clips
Spotted a mistake? Tell us →

Our articles

More articles →