← Rapid Skoda Rapid repair manuals →

Skoda Rapid (1st generation): Checking and Adjusting Tire Pressure

Check the tire pressure on your Skoda Rapid at least once a month and before any long trip. The correct values for your tire size and load are on the sticker on the inside of the fuel filler flap. Measure with the tires cold, and include the spare wheel.

DifficultyEasy Time10-15 minutes Steps9

Key figures

  • How often to check pressure
    at least once a month and before a long trip - step 1; check the spare wheel too
  • When to re-store values in the monitoring system
    every 10,000 km (6,000 miles) or once a year - steps 7-8

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№Part
01 Valve capsif neededFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

2
  • Tire pressure gauge (or an air compressor with a built-in gauge), a pump if needed Amazon →
  • a cloth for wiping the valve core Amazon →
There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online). See manuals →

Step by step

9 steps
  1. Park the car on level ground and let the tires cool down. Check them cold, meaning after the car has been parked or has driven no more than 1-2 km (about 1 mile). Don't release air from warm tires, because the pressure will drop below the correct value once they cool.
  2. Open the fuel filler flap. On the inside there is a sticker with a table of tire sizes and pressures. Find the row for your tire size, which is printed on the tire sidewall (for example, 185/60 R15 or 195/55 R16).
  3. Choose the column that matches your load: partial load, increased comfort at partial load, or full load. The "comfort" setting slightly increases fuel consumption, so for normal driving use the column that matches your load.
  4. Unscrew the valve cap on the first wheel, press the gauge firmly onto the valve core so no air hisses out, and read the value. Compare it with the table on the sticker.
  5. If the pressure is below the specification, add air in short bursts and recheck. If it is above, press the valve core pin to release air, then check again with the gauge. The difference between the wheels on the same axle should be as small as possible.
  6. Repeat for all four wheels and for the spare wheel (it should also be checked at least once a month). Screw the valve caps back on.
  7. If your car has a tire pressure monitoring system (an indicator that works from changes in wheel circumference), store the new values after inflating. Turn the ignition on, press and hold the system button (inside the cabin, near the selector or around the instrument cluster; see the owner's manual) until the indicator lamp lights up and a signal sounds, then release the button.
  8. Store the values again after every pressure change, wheel replacement, or wheel rotation, whenever the indicator lamp comes on, and also every 10,000 km (6,000 miles) or once a year.
  9. Inspect the tires for cuts, bulges, foreign objects, and uneven wear. Uneven tread wear is a sign of incorrect pressure or incorrect wheel alignment.

Common mistakes and warnings

  • Underinflated and overinflated tires shorten tire life, worsen handling, and can lead to tire failure, especially at high speed
  • The monitoring system will not warn you about a sudden loss of air (for example, from a cut), and if the values were stored incorrectly, it may stay silent even with a flat tire
  • Pressure monitoring remains the driver's responsibility
  • Take pressure figures only from the sticker on the fuel filler flap for your tire size
Spotted a mistake? Tell us →

Our articles

More articles →