← 4-Runner Toyota 4-Runner repair manuals →

Toyota 4Runner (2nd generation, N120/N130): Instrument Panel Switch Locations and Functions

The 1993 4Runner belongs to the second generation (N120/N130). The controls are divided into three zones: the steering column stalks, the center of the dash, and the levers on the console and under the dash. Trim level and market affect which switches are fitted: some items, such as the altimeter, inclinometer, seat heaters and sunroof, are not present on every vehicle.

DifficultyEasy Time15-20 minutesgetting familiar with the controls Steps11 ToolsNone required

Diagram: the instrument cluster and what it shows

View of the instrument cluster from the driver seatCHECKx1000 rpmkm/h1Speedometer2Tachometer3Fuel gauge4Engine temperature5Trip meter reset6CHECK lampTap to enlarge
  1. 1Speedometer and odometer: show speed and mileage.
  2. 2Tachometer: not on every version, shows engine rpm.
  3. 3Fuel level gauge.
  4. 4Engine temperature gauge.
  5. 5Trip meter: the reset button is on the cluster itself.
  6. 6Engine fault warning lamp: after switching the ignition on, check the warning lamp block.

Parts

4
№Part
01 Combination switch for lights and turn signalsif faultyFind on Amazon →
02 Combination switch for windshield wiper and washerif faultyFind on Amazon →
03 Rear window defogger switchif faultyFind on Amazon →
04 Hazard warning switchif faultyFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes and 10 more. See manuals →

Step by step

11 steps
  1. Instrument cluster (in front of the driver). Speedometer, odometer, trip meter with a reset button, fuel gauge, engine coolant temperature gauge, turn signal indicator lights and the warning light block. Versions with a tachometer also add a tachometer, voltmeter and oil pressure gauge. The trip meter reset button is located on the instrument cluster itself.
  2. Indicator and warning lights. Brake system warning, battery charge, oil pressure, engine system malfunction, ABS, door ajar, SRS airbag, high beam, turn signal indicators, hazard warning, rear window defogger, rear fog light, automatic transmission 4th gear (O/D). Some versions also have a glow plug light, a fuel filter clogging light and a C.DIFF LOCK indicator. A light may be red or yellow depending on the trim level, and this does not mean your vehicle has all of these systems.
  3. Right steering column stalk: lights and turn signals. The stalk has OFF, TAIL (parking lights) and HEAD (headlights) positions. Pushing the stalk forward or back switches between high beams and low beams. Pulling the stalk toward you flashes the high beams (FLASH). The turn signals are operated by moving the stalk up and down.
  4. Second steering column stalk: windshield wiper and washer. Positions: OFF, MIST (single sweep), LO (slow), HI (fast). The washer is activated by pushing or pulling the stalk. Some versions have a mode that washes and wipes at the same time. Before removing the switch, disconnect the battery and disable the airbag.
  5. Rear window: wiper and washer. They are operated by a switch in the center of the dash. Positions: OFF, intermittent (INT), continuous (ON) and washer (WASHER). The rear window washer works separately from the front one.
  6. Center of the dash. This is where you will find the hazard warning switch, the rear window defogger switch, the rear window wiper and washer switch, the outside mirror adjuster (if power mirrors are fitted), the cigarette lighter, the ashtray, the radio and the heater and air conditioning controls. The central door lock and power window switches are located on the doors and near the driver.
  7. To the left of the steering column and under the dash. The instrument panel brightness control, the rear fog light switch, the hood release lever and the fuel filler door release lever. The tilt steering column adjustment lever is located under the column.
  8. 4WD (four-wheel drive). The front axle drive shift lever is on the console next to the transmission shift lever. The front axle drive control is located on the dash. The C.DIFF LOCK indicator on the instrument cluster comes on when the differential is locked. For the modes, see the pictograms on the dash and the owner's manual for your trim level.
  9. Cruise control (if fitted). A separate system with its own control unit. Its controls are its own and are not part of the standard dash set.
  10. Function check. Turn the ignition on, then check each switch in turn. If a lever does not stay in position, a light does not come on, or the wiper does not work in all modes, the switch is most likely faulty. Replacing the column switches requires removing the steering wheel and the column cover, so disconnect the battery first.
  11. Torque specifications. They are not needed for this reference task. If you remove the steering wheel or the switches, check the fastener torque against the manufacturer's specification.

Common mistakes and warnings

  • When removing the column switches on a vehicle with an SRS airbag, you must disconnect the battery and wait before starting work
  • Then check the alignment of the airbag spiral cable (clock spring) when you install the steering wheel
  • If you have no experience working with SRS, take the vehicle to a repair shop
  • Switch names and the set of switches depend on the market and trim level, so match the pictograms to your vehicle
Spotted a mistake? Tell us →

Our articles

More articles →