← XC60 Volvo XC60 repair manuals →

Volvo XC60 II (2019): Auxiliary Engine Heater Maintenance

The auxiliary heater on the XC60 II runs on fuel from the vehicle's tank. It warms the coolant and the cabin before you drive. Only a specialist should service the heater itself: it needs an inspection at least every 2 years, while the owner runs it for 20 minutes once a month and checks the exhaust, the fuse and the connectors. These steps are for vehicles with a factory-installed heater.

DifficultyEasy Time30-40 minutesinspection and test run); service at a Webasto dealer is separate Steps20

Key figures

  • Heater inspection at a shoppreferably before winter (step 15)
    at least every 2 years
  • Monthly test runeven in summer, so the heater does not gum up (step 1)
    at least 20 minutes
  • Maximum run timethen the heater shuts off by itself (step 7)
    120 minutes
  • Restart after self-shutoffthen diagnosis (step 9)
    no more than 2 times

Check these values against the manufacturer’s specification for your vehicle before you start.

Parts

3
№Part
01 Webasto heater fuel filterif neededFind on Amazon →
02 Webasto heater glow plug or glow pinif neededFind on Amazon →
03 Webasto heater exhaust sealsif neededFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

2
  • None needed for the inspection Amazon →
  • to inspect the heater exhaust pipe, you need a flashlight and a lift or inspection pit Amazon →
There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes and 4 more. See manuals →

Step by step

20 steps · 5 stages
Stage 1 of 5 Regular run (in summer and during infrequent use) 5 steps
  1. Once a month, run the heater for at least 20 minutes, even in summer. This keeps the combustion chamber and fuel system from coking up.
  2. Run it only outdoors. Never turn the heater on in a closed garage without exhaust ventilation, including timer-based starts.
  3. Do not turn the heater on at gas stations, near fuel depots, or anywhere there are fuel vapors or flammable dust. Turn the heater off before refueling.
  4. If the vehicle is parked on a steep slope, park it facing downhill so fuel is supplied to the heater. This follows from the Volvo manual for this vehicle generation.
  5. While it runs, listen to the sound: a steady burner hum is normal. Sudden unusual combustion noises, heavy smoke or a burning smell are reasons to switch the heater off immediately.
Stage 2 of 5 Operating habits that extend service life 4 steps
  1. Make the heating time roughly equal to the length of the drive that follows. For example, for a 20-minute drive, run the heater no more than 20 minutes. Otherwise the heater drains the battery, especially on short trips.
  2. The maximum run time of the factory heater is 120 minutes, after which it shuts off.
  3. The heater shuts off by itself when the battery charge or fuel level is low, and a message appears on the display. Do not try to restart it several times in a row.
  4. If the heater shuts off on its own (it did not ignite on the start attempt or the flame went out), switch it off and on again, but no more than 2 times. After that, have it diagnosed, or it will go into lockout.
Stage 3 of 5 Visual inspection 5 steps
  1. Switch the heater off and let it cool. Wash the vehicle only after the heater is off, and do not aim a pressure washer or compressed air at the heater or its exhaust.
  2. Raise the vehicle or position it over an inspection pit and look at the heater exhaust pipe, which exits near the right front wheel arch. Check that the corrugated pipe is intact, the clamps are in place, and the heat shielding is not melted or damaged.
  3. If you smell exhaust in the cabin in winter while the heater is running, check the corrugated pipe, its joints and the heat shielding in the fender. Owners report that this assembly can be a weak point. It is better to replace damaged parts than to cover them with tape.
  4. Check the heater fuse and connectors: they should show no signs of heat damage or oxidation and should sit tightly. For the fuse rating and location, see the fuse box diagram for your vehicle.
  5. Check the battery terminals and the ground connection: poor power supply is a common reason the heater does not start.
Stage 4 of 5 Service by a specialist 4 steps
  1. At least once every 2 years, and preferably before the cold season starts, take the heater to a shop that works with Webasto for inspection. The technician checks the burner, glow plug, fuel system and exhaust and, if necessary, adjusts the heater with special instruments.
  2. Do not adjust the heater yourself: incorrect adjustment leads to heater failure and can be dangerous. The shop determines the fasteners and tightening torques for heater components according to the manufacturer's specifications.
  3. If it smokes heavily, gives off a burning smell, or makes unusual noise, switch it off, pull the fuse and have the vehicle diagnosed.
  4. If the heater went into lockout after failed starts and restarting does not help, check the power supply and ground (step 14) and contact a repair shop.
Stage 5 of 5 Check after maintenance 2 steps
  1. Start the heater on a cold engine and wait 20 minutes: the heater core should get hot, and no error messages should appear on the display.
  2. After it runs, check under the vehicle for fuel leaks at the heater and its fuel lines.

Common mistakes and warnings

  • The heater burns fuel and produces exhaust gases: do not run it in an enclosed space, at gas stations or near flammable vapors
  • Leave assembly, adjustment and fuel system work on the heater to specialists
Spotted a mistake? Tell us →

Our articles

More articles →