Daewoo Gentra Delphi MT60 - fault code P0315.
We have a Daewoo Gentra with a Delphi MT60 - fault code P0315. Scanmatic2 interprets it as an untrained crankshaft sensor. It is diagnosed with the MT80 module. When trying to run the adaptation it gives an error, something like "access denied", even though it sees the data and conditions fine (brake pedal pressed, temperature). The question: which tools already list this car with this ECU? And who has already done the adaptation, and with what?
I sent you a link to Scandoc in a private message.
Did you do it successfully with it? Was that long ago? I tried it once and it didn't work with Scandoc.
Same here, Launch with the July update didn't do it either. The Daewoo module does include the Gentra, but only with the old engines.
I'm still leaning toward incorrect programming of this ECU, or an incorrect file being loaded into it. In all the time I worked on these cars under warranty, I never saw this error, either after replacing the ECU or with any system faults. Time will tell. And a question to the participants: how can a third-party scanner perform procedures that aren't listed in the dealer tool?
A third-party scanner can easily do that.
I haven't seen any examples in my practice, but I mainly work with GM and VAZ. On GM scanners there doesn't seem to be anything like that, where a third-party tool is better with extra functions.
Right, especially with a focus on UzGM.
On a car with an automatic transmission, errors P060C, P2105 and P2106 appeared after programming. I haven't figured out the cause yet, maybe someone has had this. I haven't rolled back to the stock file yet.
Either the checksum wasn't calculated properly, or the parameters related to throttle control failed the compliance check.
These ECUs also die for no reason, with the same errors on board. I have two such units on the shelf. One simply stopped starting, the other works depending on its mood. I just haven't gotten around to it. I'm thinking of looking into replacing the flash contents. We talked to SS, and for now the Gentra is in their plans.
The one thing I don't understand is what all the latest posts have to do with the topic starter's question. If you have a problem, create your own new thread. Why mix everything together? PS: Also, if you carelessly touch the calibrations responsible for the throttle position sensor calibration, you'll get the same thing.