Citroen C4 Picasso fault code P1030
Citroen C4 Picasso VF7UD5FS0BJ570077, the cylinder head was repaired. The check engine light is on with fault code P1030 - Variable valve lift system learning fault: Correlation. I can't work out what is correlated with what. The fault clears and comes straight back, and the engine won't start. Please advise if you have run into this.
The system can't learn the variable valve lift mechanism. This happens when the intermediate shaft of the intake valves is installed incorrectly, when the mechanism connecting the motor to this shaft is damaged, or when the motor itself is faulty.
What are you diagnosing with?
I'm trying with Scandoc, I have nothing else for these cars.
Why won't it clear with the engine not running, and how can I check that the intermediate shaft is installed correctly? I found how to check the camshafts, but nothing about the intermediate shaft.
Learning takes place as soon as the ignition is switched on, so there's no need to start the engine. The camshafts have nothing to do with it. The fault is not about the valve timing phases, but about the valve lift variation. A bit later I'll get home and look up the procedure for installing the intermediate shaft.
As I understand it, learning won't start while the fault is present. I can't clear it with the scanner.
It can't be cleared because the end positions of the adjustment motor are not recognized. As for why, there can be many causes. What position was the intermediate shaft in when you engaged it with the worm gear of the motor?
The engine mechanics installed it. I'll question them tomorrow. I'd be grateful for the procedure for installing the intermediate shaft.
Well, calling it a procedure is a bit of a stretch. I've sent it to you privately. This is the position it is set in during assembly.
Thanks, we'll check. The mechanic says he only replaced the cylinder head gasket and didn't even unbolt the intermediate shaft.
We checked and corrected the shafts. The valve lift system no longer reports a fault. After starting, the engine runs normally for about a minute, then begins to run on three cylinders until fault codes P1336 and P1337 (1338; 1339) appear, the check engine light comes on and the cooling fan switches on. The injectors and spark plugs are new, they were replaced along with the cylinder head gasket. Where can I find information on the EP6C engine? I can't find anything substantial online, only fragments.