Citroen Berlingo 1.9D WJY BSI problem
Help me figure this out. Citroen Berlingo 1.9D WJY 2004, BSI problem: the side lights on the left side came on. I replaced the BSI with a new one and entered the PIN code. I started the car and the side lights went out, but the check engine light came on. In PP2000 the errors show "pump module not paired - not unlocked", but in the measurements everything is unlocked and no problems are found. How can I fix this problem?
Train it again from scratch. When you go for the training, before the final confirmation, disconnect the battery, wait, put it back and go ahead. The French programmers are about as good as a Tajik at merchandising.
Thanks, I'll try it. The new BSI started acting up anyway. It lasted 3 days. If the side lights are on, the low beam doesn't light. I started the car and turned on the low beam, and the side lights on the left side went out. I'm looking for bad grounds and power feeds. It seems to work, then again the same thing. What is going on...
You understand that a working unit can't "act up". The low and high beams are switched on by the underhood unit on a command from the BSI, and you can see it all in the parameters. The side lights, in my opinion, come from the BSI, but I may be wrong. I'll look at the diagram now... if you post the VIN.
Thanks, I'll try it. The new BSI started acting up anyway. It lasted 3 days. If the side lights are on, the low beam doesn't light. I started the car and turned on the low beam, and the side lights on the left side went out. I'm looking for bad grounds and power feeds. It seems to work, then again the same thing. What is going on...
You understand that a working unit can't "act up". The low and high beams are switched on by the underhood unit on a command from the BSI, and you can see it all in the parameters. The side lights, in my opinion, come from the BSI, but I may be wrong. I'll look at the diagram now... if you post the VIN.
VF7GBWJYB94140832. There is a constant error in the BSI (left-side side light control). With the old BSI installed there are no errors, but the side light is on all the time.
Try correcting the configuration manually in the telecoding, but for that you need to know the car's equipment in full detail. By the way, for Citroens you need LEXIA2, not PPS. Just in case, also check the battery charge.
I set up the BSI clean as far as side light control goes, there are no equipment options or telecoding. The car is practically bare. I'd like a proper BSI diagram, I probably messed up somewhere with the power feed.
VF7GBWJYB94140832. There is a constant error in the BSI (left-side side light control). With the old BSI installed there are no errors, but the side light is on all the time.
Pull fuse F2 out of the underhood unit and tape over its slot with tape/electrical tape, so that nobody ever puts it back in. And you'll be happy.
Why? Please explain.