Fusion 2007 clutch overheating
Hello! We have a 2007 Fusion 1.4 with the robotised gearbox. After 30 minutes of use, P2787-20 (clutch) comes up. The clutch and release bearing are new and original, and the IMS is from another car that is known to be good. The ABS bearings show equal speeds with no noise, distortion, jumps or divergence. Has anyone run into this and worked out what it wants? PS: I have been doing IMS on these for more than 10 years. Adaptations: SD, IDS, FS. The flywheel is ideal and has even been resurfaced. The touch point is 12.8, from Google. I suspect the problem is specific to the Fusion and doesn't show up on the Fiesta, but that's not certain. If you have thoughts or experience, please share. Answers like "bad adaptation" are appreciated, of course, but I'd like some useful advice.
Either the adaptation was done badly, or the flywheel is worn. What did you use to do the adaptation?
Was the gearbox swapped by any chance? If so, look at the clutch slip in the data stream on different gears.
The history is unknown. The owner has had the car for 3 months. For 2 months it ran fine, and for the last month it has been in my workshop. The slip is 650-700 at idle and at traffic lights. While driving it is under 100, or even 90, and under hard acceleration 150-180.
It's down to the robotised gearbox. Did you check the brushes?
I meant the slip with a gear already engaged. Look at the clutch slip in 2nd/3rd/4th gear and monitor the clutch temperature. There should be none. Slip should only occur at the moment of shifting. If, with a gear engaged, the data stream shows clutch slip while the wheels are not actually slipping, and the higher the gear the higher the slip, it means the gearbox is from the manual version. In 3rd gear the slip will be about 150-200 rpm, and the calculated clutch temperature will be above 300 degrees after 3 minutes of driving. It has a different final drive ratio. You should also check that the programmed final drive value and the tyre size are correct.
Spot on! The wheels are the right ones, but I can't find the final drive ratio anywhere. It isn't listed for the Fiesta or the Fusion. It should be 4.25, but in reality it's unknown. The only ideas left are to change either the ABS or the gearbox. With the tools I have, nobody gets into the Fusion's ABS. I called the official dealer about updating the ABS, and got silence and incomprehension.
You can see the final drive ratio and tyre size in the PCM reprogramming section of IDS. You don't need to actually do the reprogramming.
Thanks! I'll go and start IDS (it keeps crashing, and I don't want to "freeze" it because I only need it a couple of times a year, and Scandoc with Forscan covers all the main functions). The car's history is unknown. But what bothers me is that it ran for 2 months, and the customer doesn't look like a trickster.
That's the thing: a bad adaptation is the real culprit on these, especially if it's done with Scandoc. The numbers look fine, but in practice it behaves erratically. Sometimes it only starts working properly on about the third attempt. It's hot here in summer, and this is a fairly common fault after a clutch replacement.
In case it's useful to anyone: the final drive ratio is 4.06 for the manual gearbox and 4.25 for the robotised one. So at 60 km/h the car calculates that it is delivering torque at 62.8. That makes it detect clutch slip that doesn't exist in reality, and it calculates a disc temperature above 300 degrees. After that it drives "normally" but in limp mode with harsh shifts.
IDS changes the final drive number. I did it myself when replacing the PCM.
Either I'm an idiot, or my IDS is completely broken.