← Ford

Ford Focus 2 2.0 automatic transmission – limp mode

Ford Focus 11 answers Translated from Russian · original

After a reprogram, the car started dropping into limp mode, with no fault codes. The first and fourth cylinders stop working, even though there is spark and injector control. I put the stock 7M51YG back and flashed software from a shop. The KAM was reset with a Scandoc, with no result. After a restart the car runs normally. It may work right away, or it may take 3-4 tries. The customer says he never had this problem before the reprogram, though who knows. The MAP sensor was cleaned with alcohol, there are no vacuum leaks, and the coils work. I don't know where to look. In limp mode the vacuum is 60-70, fuel trims are +30% and engine load is about 40%. After a restart everything is perfect.

Answers
O
Owner Mar 07, 2020

The check engine light is on, no codes?

O
Owner Mar 18, 2020

No codes. Injection time in limp mode is 6.0 ms on all injectors, and 3.5 without limp mode. The spark shows no difference at all.

O
Owner Apr 05, 2020

For future reference, please write the make and model in the title in Latin letters. I fixed the title.

O
Owner Apr 20, 2020

Thanks. The car doesn't react to unplugging the connectors of coils 1 and 4. The pulse to the injectors is there and the spark is there, so how do I make sense of this? There is compression. Could the swirl flaps block the intake completely? Spark plugs 1 and 4 are black, 2 and 3 are normal.

O
Owner May 07, 2020

Are you sure you loaded the stock file afterwards? All the symptoms are the same as with a throttle fault.

O
Owner May 18, 2020

I'm sure it was the stock file. With a throttle fault, injection gets cut, but my injection time is the same on all injectors. I'm checking everything with an oscilloscope.

O
Owner May 31, 2020

Is the spark on time?

O
Owner Sep 19, 2020

What equipment did you use for the reprogram?

O
Owner Apr 10, 2021

I don't want to jump to conclusions. The car is being driven and tested, but it looks like the cause was two spark plugs that had been tightened far too much, even though the oscilloscope showed everything was fine. In any case, it stopped acting up after I replaced them with used ones from a box. Don't close the topic yet, the customer will call back in a couple of days. I worked with a Combi.

O
Owner Jul 23, 2021

I bet the reprogram had nothing to do with it. We'll wait and see.

O
Owner Aug 05, 2021

I really hope you're right, as always :)

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →