← Renault

Renault Logan 2: ABS problem, automatic transmission

Renault Logan 11 answers Translated from Russian · original

Hi all, here is the story: after the right front bearing was replaced, the ABS stopped working and the reverse gear started to drop out from time to time on the automatic transmission. I don't know how the bearing was replaced, but the ABS unit itself died. The wires from the unit connector to the sensor connector ring out fine, but with the ignition on the sensor connector shows 2.3V, unlike the left side, where the connector shows 9.7V. Question: can an ABS unit fault affect engagement of reverse like this? The car drives forward (I don't know whether in limp mode or normally), but when reverse is selected, R flashes on the display and the gear does not engage. The transmission has fault DF240, front right wheel speed 655 km/h.

Answers
O
Owner Aug 27, 2020

Yes, it can. For it to work, the transmission needs both working front wheel sensors and the front wheel tone rings (targets).

O
Owner Sep 12, 2020

There is a catch. Faults in this ABS may not clear with the normal clear-codes command. Among the special functions there is a "reset" command, and that is what erases the faults. So don't rush to replace the ECU. I measured the reference voltage at the connectors a long time ago and don't remember what it was under which conditions.

O
Owner Sep 29, 2020

If you disconnect the shift control from the gearbox completely, should reverse logically appear?

O
Owner Nov 16, 2020

Scandoc shows zero speed on all wheels (car stationary), Launch shows 655 for the front right wheel. Launch has special functions, but there is no reset there. There is something like a tooth count, but that function is not possible on this wheel. I don't have the factory manual for the French cars. That's about it. I tried disconnecting the ABS unit and reverse still didn't appear. But according to the owner, it sometimes appears by itself. So I'll have to buy a Chinese-made manual.

O
Owner Mar 04, 2021

Connect the left sensor in parallel to the right one, or swap the rear one for the front right, and watch the gearbox.

O
Owner May 06, 2021

The car was picked up right away. It belongs to taxi drivers, who don't care. They manage fine without reverse. When it comes back, I'll finish the thread.

O
Owner Jul 17, 2021

Good day everyone. Sorry, I can't create a new thread. The situation is exactly the same: Renault Logan 2017, fault DF240 (front right) appeared, according to the owner, a week after a ball joint was replaced (possibly a coincidence). The sensors were swapped from right to left, and the bearing was replaced, with no result. The car is currently standing. Please point me in the right direction.

O
Owner Dec 16, 2021

Does the fault appear right when the ignition is switched on, or while driving?

O
Owner Feb 14, 2022

It happens at a speed of 45 km/h.

O
Owner Apr 21, 2022

A lift and an oscilloscope. Where else is there to point?

O
Owner May 02, 2022

Remove the driveshaft, blow out any debris around the tone ring, and clean the tone ring itself. Then do a test drive. If the fault comes back, run a tone ring test with the scanner, determine the number of poles and compare it with the tone rings on the other wheels.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →