← Kia

Kia Sorento 2.5L Diesel. Stalls Occasionally

Kia Sorento · 2005 9 answers Translated from Russian · original

Hi all. I have a problem with a 2005 Kia Sorento 2.5 diesel. It stalls occasionally, and in different situations: sometimes on the highway, sometimes during a quick stop at a shop, and then there is silence. If you walk around the car for about 5 minutes, or pump up the pump (primer), it starts. It doesn't make sense. Specialists say there can be a problem where the crankshaft position sensor wire rots. But it isn't, it's intact. I don't know. We checked all the wires and all the terminals, and everything is intact, with not even a trace of green corrosion. It doesn't make sense. Can anyone suggest what it might be?

Answers
O
Owner May 17, 2020

You could try connecting a scanner and see which errors are present. A diesel doesn't like air in the fuel. Fit a transparent hose on the return line and watch it when the car won't start.

O
Owner Jul 03, 2020

There should be errors in any case if it's the fuel system. If there are none, try disconnecting the aftermarket (non-factory) equipment. Maybe a relay there is glitching.

O
Owner Jul 28, 2020

There is an emergency valve on the fuel rail, at the end of it. Take the hose off it, start the engine and let it idle. It should be dry. If diesel is leaking out, replace it.

O
Owner Oct 06, 2021

Thanks for the information. But after I poked around, took off all the terminals and put them back, opened the return valve on the filter and bled the system, it hasn't stalled so far. Who knows when to catch it. I'm waiting for the moment it stalls. And it just keeps driving and driving without stalling.

O
Owner Dec 24, 2021

I had one like that, it stalled too. I removed the crankshaft position sensor and cleaned the metal shavings off it. Inside the cabin, in the front passenger's footwell on the right under a plastic cover, there are many connectors that water likes to get into. I cleaned them all. Half a year has passed and it doesn't stall. Also, the crankshaft position sensors on these do fail. When heated, the internal resistance rises to 5 kOhm, against a nominal 800 Ohm. While the engine is running it is enough, but once it's shut off it's no longer enough. The engine won't start.

O
Owner Jan 13, 2022

The catch here is that it stalls whenever it feels like it. Sometimes during a quick stop at a shop (according to the customer, of course), sometimes at 130 km/h on the highway. Sometimes in town it's standing at a traffic light, idling, and then it just stalls. So there is no causal link. Air when the filters were replaced is possible, but it was bled and the defect didn't go away. I checked the crankshaft position sensor and went through the whole harness, and it's intact, with not even a trace of green corrosion. Nothing. It's as clean as from the factory. The check engine light is not on, and it shows no errors at all. That's the situation. But it does stall sometimes, and that's it. And it's unclear when. It stalls whenever it feels like it.

O
Owner Feb 06, 2022

Open up the main relay and look at the solder joints. The contacts often come loose and strange things start to happen.

O
Owner Feb 14, 2022

Debris on the regulator in the rail. Also the clutch pedal switch, if it's a manual gearbox.

O
Owner Mar 27, 2022

OK. Thanks, I'll take a look. But for now it isn't stalling, damn it. Well, there you go.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →