Kia Rio 2005 - The car uses 10 liters of fuel per 100 km
A Kia Rio from 2005 has come in, mileage 43000 km. Engine 1.4 16V. The car uses 10 liters of petrol per 100 km. I couldn't connect to it with anything. I tried Scanmatik and Vehicle Explorer. The ECU is a Kefico, but not the 797 analog. Kefico 9030930617AO E3 GJB-634DFSO-5000 39100-26AC1. I couldn't take a photo because I didn't have a camera on hand. What kind of unit is this? Could the problem be in the firmware? Can it be programmed with the Pashin bootloader?
Do you have a gas analyzer? Let's see the data. Don't forget to check the condition of the spark plugs.
I changed the spark plugs two days ago. CO2 14.5, CH 050, CO 0.02, O2 0.62
This is an M798, isn't it? The customer says it has used a lot of fuel since he bought it. At first he thought it was because of the break-in period, but now he wants it to match the spec of 5.8. Are there any known problems with these ECUs?
Try going for a drive with the customer. Maybe his driving style is gas-brake, or there is a problem with the manual transmission.
There are a lot of possible causes: wheel alignment is off, tire pressure, driving style, short trips and many other related things. With this CO and CH, even for this engine, the consumption is normal.
Leave the engine alone. Most likely it's fine. Just consider the ratio of engine power to the total weight of the car, and add the quality of our fuel. Then you'll understand everything. The spec sheet gives the CALCULATED fuel consumption, which was worked out assuming ideal petrol. In general, consumption should be measured on the highway. That will give you the real figures. Just don't give the customer a reason or a chance to cheat you. And by the way, the Kia Rio has never been known for fuel economy.
I think it's still worth running diagnostics. And of course, go for a drive with the customer and measure the consumption accurately.
The thermostat may be faulty. If the car doesn't warm up, it will also use a lot of fuel. In general, it's a sore subject. Proving to the customer that his high consumption comes from short trips is a hopeless task. I wish someone would make a program that measures integral consumption over even 5 kilometers. That would be great.
No, the thermostat is fine. I forgot to say that the customer complains the car is sluggish, but it has 97 horsepower, so surely the engine can pull the weight of the car?
As far as I remember it's an E3, right? Also, the gas analysis shows too little oxygen. What does the lambda read on the gas analyzer? Take 2 measurements, one at idle and one at higher revs. With the scanner: it connects fine, both through model selection and through OBD, but only if you go through the KIA menu. I think it has its own OBD protocol. That is how Korean cars differ from European ones in terms of diagnostics.
Oh, come on. 10 liters is normal. This isn't an Oka, and even that can use 10. Look up at what rpm this engine makes maximum torque and advise the customer to drive within +/- 500 rpm of it, in all gears (except first). But it still won't use much less, that's just how they consume. I had one like this, a 2004, with Scanmatik over OBD.
If the customer comes in, I'll send the measurements.