← BMW

BMW X6 E71 N54 not running right after cylinder head repair

BMW X6 · 2008 9 answers Translated from Russian · original

5UXFG43518L220549, 2008, mileage: 147735 km. History from another shop: the car died and was brought in on a tow truck. It started very badly, ran rough and sputtered, and would not drive at all. With no diagnostics and no measurements, on the strength of oil floating in the expansion tank, they decided the cylinder head needed repair. They reassembled it and started it, and little changed. It only began to respond to the pedal. I came and looked at it. I cleared about 30 engine faults and the adaptations, and warmed it up. It ran fairly well with no faults. My gut feeling was right)) I said to let it cool down and check it again. Start-up was the same, with these faults: 2C9D Oxygen sensor 2 heater before catalytic converter; 2A87 VANOS (exhaust), mechanism; 3100 boost pressure control, shutoff; 2AAF fuel pump, plausibility. After warming up, misfires on cylinder 5 also appeared. In the VANOS data: intake position 125, adaptation 0.74; exhaust position -107, adaptation 19.11. Throttle 31. Air mass at 650 rpm: 28 kg. I will check the intake tract for leaks a bit later. Gurus, what else should I check? The engine was assembled using the proper tools. The engine builder insists everything was assembled correctly.

Answers
O
Owner Mar 28, 2020

Check all the connectors. Are there any injector faults? Check the fuel pressure from the tank to the high-pressure pump, which should be 5 bar. (And what does the rail show?) It's also unknown how they set the timing marks. Are you running ISTA (Rheingold) diagnostics?

O
Owner Apr 07, 2020

Low pressure 5, high pressure 50. The only faults are the ones in the first post.

O
Owner Apr 07, 2020

The VANOS itself may have broken down. The oil in the tank is 90% likely due to the oil cooler or filter gaskets. The large number of faults may be the result of a loose ground connection.

O
Owner Apr 18, 2020

In limp mode, what is the position of the shafts? Run the test plan for pressure.

O
Owner May 11, 2020

I gave the shaft positions with the active faults.

O
Owner Jun 07, 2020

What stops you from at least swapping the valves around?

O
Owner Jan 03, 2021

Not knowing how. I know BMW like I know ballet. I'll try tomorrow.

O
Owner Jul 20, 2021

Clean the valves, swap them with each other, and clean the channel screens (the plugs slightly above the hydraulic tensioner in the cylinder head).

O
Owner Jan 25, 2022

How is it going?

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →