← Honda

Honda Shuttle 1995 2.2 engine knocking

Honda Shuttle · 1995 10 answers Translated from Russian · original

Honda Shuttle 2.2. A ringing knock, similar to a diesel knock, appears from time to time. When the car is standing there is no knock. It only appears while driving, when revs are rising. It doesn't seem to be mechanical: the valve clearances are adjusted and the bearing shells were checked. The engine is also a swap (from a low-mileage car). There are no fault codes and the data is all fine. Can anyone suggest something?

Answers
O
Owner May 08, 2020

Sorry, but I last saw a Shuttle many years ago, and I doubt the engine is a 2.2. I don't think they came with anything bigger than 1.6. On the topic: if the engine has low mileage and the cars stopped being made in 94-95, the engine may have been lying around for about 10 years. One possibility is piston skirt knock because of stuck rings. There were cases where swapped engines came alive after two or three months, stopped using oil and started pulling like a young engine. There is too little information.

O
Owner Jul 14, 2020

Maybe you could post an audio file. We'll listen to how it knocks. 2.2 is normal for the Shuttle. Don't confuse the Shuttle with the Civic Shuttle.

O
Owner Aug 06, 2020

They were made from 1995 to 2001. It doesn't use any oil.

O
Owner Nov 22, 2020

If it knocks under load, it is most likely a piston pin. Disconnect the injectors one at a time and drive. The cylinder where the knock stops is the one with the worn pin. If it keeps knocking, it is 90% the piston skirt.

O
Owner Feb 07, 2021

Good grief, so this is the Odyssey! I've never seen this car, and it isn't even in the catalog on Drom. :tease: If it looks like the Odyssey, check the catalytic converter in the middle of the cabin.

O
Owner Jun 02, 2021

Hello everyone, I have almost the same problem. The car is a 1995 Honda Shuttle with an F22B8. I fitted a used engine from Japan (the old one was completely worn out). After a while I noticed an unusual sound that only appears while driving, that is, under load. At standstill, there is nothing to hear at idle or at higher revs. The sound isn't dull. At first it seemed like some valve was rattling. I went through everything and found clogged passages in the plate where the EGR is mounted, and cleaned it all out, but... The engine runs smoothly and there is no oil consumption at all, but this noise won't leave me alone. Also, I can't work out any pattern to when it appears. I can drive for a while and hear nothing, but once I stall it and start it again, there it is, rattling. Maybe there is a solution or a way to track it down. I'd be grateful for help.

O
Owner Oct 04, 2021

Problems like this are the hardest. Sometimes I managed to find something by taking a vacuum sensor and pressing it against the engine metal. You can go over all the fasteners ("THE ENGINE WAS RECENTLY REPLACED"), the pulley, the torque converter coupling, or something else that wasn't tightened fully.

O
Owner Nov 11, 2021

I'll check, of course. Everything seemed fine with the metal parts.

O
Owner Mar 19, 2022

I removed the upper part of the intake manifold together with the throttle body, the idle speed regulator and the MAP sensor. I replaced the rubber sealing ring on the MAP sensor; the old one was squashed and had sagged. There is a screen at the inlet of the idle speed regulator, and it was half clogged. I cleaned everything, including the throttle body, and reassembled. I set 0.45 V on the throttle position sensor signal wire with the throttle closed. I drove it for a couple of hours with no unusual noises. I started it and shut it off, and nothing. If it were a mechanical problem, the sound would have shown up right away. Tomorrow I'll keep working the car, and if anything shows up I'll report back.

O
Owner May 10, 2022

Colleague, it looks like everything is fine. On this type of car, the sensors in the distributor are mounted on one shaft, rigidly. If there were any shift, it would be hard to start, let alone drive off.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →