Nissan Primera P12, 2.0l: Engine starts and stalls after 30-50 seconds
The engine starts and stalls after 30-50 seconds, and if I press the gas it stalls immediately. There are no fault codes, fuel pressure is normal, the injectors work, there is spark, and the signals from the camshaft position sensor and crankshaft position sensor are normal and in sync. When I unplug the MAF sensor connector, idle appears, but it is very hard to rev the engine. The MAF sensor reading with the ignition on is 1.11-1.14 V. I would like to know what the MAF sensor voltage should be at rest. I really want to condemn the MAF sensor, but I'm not 100% sure and have nothing to swap it with.
A MAF sensor on a Nissan is not a death sentence yet. I don't really want to condemn it. If you really want to, take a MAF sensor from a VAZ out of your spares and connect it. A dead VAZ is a good Nissan. Now let's go into more detail. Engine: .... Fuel pressure: .... Correction coefficient: .... A screenshot of the spark. Is there any? Let's look at it, although it is most likely the coil's power stage.
You can't fit a MAF sensor from a VAZ here! First, its diameter is almost half the size, and second, the connector is completely different. The engine is a QR20DE, fuel pressure is 3.5 bar. As for the correction, I didn't understand which correction and where to look at it, at start-up? I can't post a screenshot of the spark, because there are 4 individual coils. I do have such coils and swapped them in, but it didn't help. I would like to know what the MAF sensor voltage should be at rest.
Is it a Bosch MAF sensor? Tell us that. If it is, throw the sensor away. Disconnect the connector and watch for changes.
If you had written the engine and year of manufacture right away, you would surely have been given advice by now instead of people trying to guess what engine it is. Maybe it's a diesel! Next time, write more carefully. Asking for the number on the MAF sensor is useless, so post a photo. If my memory serves me right, up to 1.4 is normal for this engine, but I will say for sure tomorrow. As for the correction, do you have a scanner? What does the fuel correction show? What does the MAF show when you try to open the throttle? What does the customer say, after what did this start?
How many times has it been said: when asking a question, write everything (MODEL, MAKE, YEAR, ENGINE SIZE, MILEAGE, WHICH MARKET) about the car in question! From what I understood, the MAF values are 0-5 V, idle 1.3-1.7 V, 2500 rpm 1.8-2.4 V. Further, with the ignition on, pin 4 to ground is 4.8-5.2 V. When a MAF sensor fault is detected, the control unit limits the revs to 2400.
Guys, why are you getting so worked up? I think everything was written clearly, and the question was specific. I even put it in bold the second time. Thanks for the more or less sensible answer: "If my memory serves me right, up to 1.4 is normal for this engine." The problem really was in the MAF sensor: on the new one the resting voltage is 0.98 V. Although this parameter isn't important at all. So do they actually have 2.0 l diesels?
Nobody is getting worked up. Just post your topic properly and there won't be such explanations. If your question is resolved, then the topic can be closed. It is customary to report that here too.