← Chevrolet

Chevy Aveo 2008 1.6 - manual transmission: how to reset the accumulated fuel correction

Chevrolet Aveo · 2008 9 answers Translated from Russian · original

Hello, Chevy Aveo with a sequential-injection LPG system. On a cold start (on petrol, of course) the accumulated correction is -30, which keeps the car from running and chokes it. Through a flushing rig I feed fuel at 6 atm. It runs, and the correction gradually works its way to about 0, and the car starts to run even at a fuel pressure of 3.8. Once it warms up, both long-term and short-term corrections are about 0, and the car drives without problems. The oxygen sensor works normally. How do I reset the accumulated correction? ECU is MT 80. There is no reset option in Scanmatic or Ultrascan, and I disconnected the battery terminal.

Answers
O
Owner Jun 28, 2020

These have known problems with these corrections. If LPG is installed, the fix is to make it Euro 0 in the software.

O
Owner Jul 08, 2020

Why? Sequential-injection LPG just needs to be adjusted correctly.

O
Owner Aug 16, 2020

Thanks, understood about Euro 0 and the LPG adjustment (I even ran it on petrol for half a day, and it still goes to -30 and runs badly when it cools down). But how do I reset them? I took the terminal off overnight.

O
Owner Aug 29, 2020

Good day. After a night with the terminal disconnected, the correction is still -30. It will go off to be flashed to Euro 0. Thanks.

O
Owner Sep 04, 2020

How will you set up the LPG afterwards without the oxygen sensor?

O
Owner Sep 15, 2020

Hmm... right. But how do I zero out the correction?

O
Owner Dec 16, 2020

This morning I tried to put the ECU into limp mode by unplugging the coolant temperature sensor connector. At start-up the temperature read -40 and the correction immediately jumped to 0. I fitted a coolant temperature sensor simulator, and it works normally at all temperatures. I reconnected the original coolant temperature sensor, and everything works, with the accumulated correction around 0. I cooled it down 3 times and started it, and it runs normally. What was that? I'm cooling it down once more and waiting for the correction to cause trouble again.

O
Owner Apr 06, 2021

There are no miracles. Obviously the fuel correction is a consequence, not a cause. There isn't enough data to make a decision.

O
Owner Apr 12, 2021

Well, the engine there is a 1.4. On the sedans there is a problem where the fuel tank vent hose gets chafed through, and dirt and water get into the tank. After it sits overnight, a lean-mixture error appears in the morning. There was a Cruze like that, which always threw the error and the correction went to 30. I found nothing, flashed it to E2 and the problem went away. I flashed it back to stock and the same thing happened again. Maybe the trouble is in the MT 80 itself. And how does oxygen sensor 1 behave at the moment the problem appears?

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →