← Vezel

Honda Vezel (1st generation): Electronic Parking Brake Adjustment

The 2019 Honda Vezel is equipped with an electronic parking brake controlled by a button below the automatic transmission selector. The adjustment is performed automatically by the electronics. When replacing the rear brake pads, the calipers must be put into service mode with a diagnostic scan tool. If the brake does not hold the vehicle or shows an error on the instrument cluster, the system needs calibration or the caliper electric motors need to be checked.

DifficultyMedium Time30-60 minutes Steps9

Parts

2
№Part
01 Parking brake switchif faultyFind on Amazon →
02 Rear caliper electric motorif faultyFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

3

Read the codes yourself

A scanner plugged into the OBD2 port under the dashboard shows which fault codes the car has stored, before you buy any parts. Cars sold in the US from 1996, and petrol cars in Europe from 2001 (diesels from 2004), have this port.

  • Basic code reader, about $20–40: reads and clears engine codes Amazon →
  • Bluetooth scanner with a phone app, about $30–100: live sensor data, and on many cars ABS and airbag codes too Amazon →

Check that the scanner lists your make and model year before you buy. We may earn a commission from qualifying purchases.

Step by step

9 steps
  1. Preparation: Park the vehicle on level ground, turn the ignition on without starting the engine, and put the selector in P. Battery voltage must be at least 12.5 V (connect a battery charger if necessary).
  2. Connect the scan tool to the OBD2 connector under the steering column, to the left of the driver.
  3. Enter the scan tool menu and select the EPB (Electronic Parking Brake) section or Brake Pad Maintenance Mode.
  4. Activate service mode. The system will automatically retract the rear caliper pistons, and you will hear the electric motors whirring (10-20 seconds).
  5. Service the rear brakes: replace the pads or check the condition of the rotors (if that is the purpose of the job). The calipers must stay in service mode until the work is finished.
  6. Exit service mode with the scan tool by selecting Exit Maintenance Mode or Calibration. The system will extend the pistons until they contact the new pads.
  7. Calibration: After exiting service mode, apply the parking brake by pulling the button up, then release it by pressing the button down. Repeat the cycle 2-3 times so the system learns the new piston positions.
  8. Holding test: Park the vehicle on a 15-20 degree slope, apply the parking brake, and shift the selector to N. The vehicle must not roll.
  9. Drag check: Fully release the parking brake and drive 50-100 meters. The rear wheels must spin freely, and the rotors must not get hot.

Common mistakes and warnings

  • Do not try to push the rear caliper pistons in by hand without activating service mode
  • Doing so will damage the electric motors and cause errors on the instrument cluster
  • Do not disconnect the battery during calibration
  • The system may log a fault and require a reset at a repair shop
  • If you do not have a scan tool, go to a Honda dealer
  • Adjusting the system without diagnostic equipment is not possible
How it works · 3D How Car Brakes Work How the part you're working on actually works — in plain English, on a 3D model. Open in 3D →
Spotted a mistake? Tell us →

Our articles

More articles →