← Pajero Sport Mitsubishi Pajero Sport repair manuals →

Mitsubishi Pajero Sport (Montero Sport) 2.4 DI-D (2018): Engine Oil and Oil Filter Change

The 4N15 engine holds 8.4 L (8.9 qt) of oil including the filter and cooler, and in practice takes about 8 L (8.5 qt) on refill. The scheduled maintenance interval is 15,000 km. Under severe conditions, shorten it to 7,500 km. Use DL-1 oil in 5W-30 or 0W-30 viscosity.

DifficultyEasy Time30-40 minutes Steps11

Parts

3
№PartGenuine part no.Alternatives
01 Oil filterFind on Amazon → 1230A182 AlternativesMANNRyco Z456
02 Drain plug gasket (14 mm diameter)Find on Amazon →
03 Engine oil DL-1 5W-308 L (8.5 qt)Find on Amazon →

Amazon links search by the part name and genuine number; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Part numbers are from the manufacturer's original catalogue. Check them against your VIN before ordering.

Tools

6
There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online). See manuals →

Step by step

11 steps
  1. Warm up the engine to operating temperature (80-90°C) and park the vehicle on a level surface over a pit or on a lift.
  2. Remove the oil filler cap to equalize pressure.
  3. Place the drain pan under the oil pan and remove the drain plug with a 17 mm wrench (be careful, the oil is hot).
  4. Wait for the oil to drain completely (5-7 minutes).
  5. Replace the copper drain plug gasket with a new one and tighten the plug to 39 ± 5 N·m (29 ± 4 lb-ft).
  6. Unscrew the old oil filter (located on the bottom, near the crankshaft pulley). Use an oil filter wrench if necessary.
  7. Wipe the filter mounting surface and lubricate the rubber gasket of the new filter with fresh oil.
  8. Install the new filter by hand until the gasket makes contact, then tighten it another 3/4 turn (do not use a tool to tighten).
  9. Pour in 8 L (8.5 qt) of fresh oil through a funnel.
  10. Start the engine and let it run for 1-2 minutes, then shut it off. After 3-5 minutes, check the level with the dipstick (it should be between MIN and MAX) and top off if necessary.
  11. Inspect the drain plug and the filter for leaks.

Common mistakes and warnings

  • Do not overtighten the oil filter with a tool. 3/4 of a turn by hand after contact is enough
  • Overtightening will damage the rubber gasket and cause a leak
  • Use DL-1 oil
  • Standard diesel oils meeting API CJ-4 or ACEA E9 are also suitable, but exact DL-1 compliance ensures optimal protection for the diesel particulate filter and the exhaust aftertreatment system
Spotted a mistake? Tell us →