← Kyron SsangYong Kyron repair manuals →

SsangYong Kyron 2.0 XDi (2010): Wiper Blade Replacement

The 2010 SsangYong Kyron uses classic hook-type (J-hook) wiper blade attachments. The replacement is done by hand without tools in a few minutes. It is recommended to replace the blades every 6-12 months, or whenever streaks appear on the glass.

DifficultyEasy Time5-10 minutes Steps9 ToolsNone required

Parts

2
№PartGenuine part no.Alternatives
01 Driver-side wiper blade 550 mm (22")Find on Amazon → AlternativesBosch AeroTwin AR22UDenso DUR-055L
02 Passenger-side wiper blade 500 mm (20")Find on Amazon → 7832509001 AlternativesBosch AeroTwin AR20UDenso DUR-050L

Amazon links search by the part name and genuine number; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Part numbers are from the manufacturer's original catalogue. Check them against your VIN before ordering.

There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online). See manuals →

Step by step

9 steps
  1. Lift the wiper arm away from the windshield to the upright position until it locks. Start on the driver's side.
  2. Turn the blade perpendicular to the arm to get access to the plastic retaining clip.
  3. Press the plastic release tab on the side of the blade and at the same time pull the blade down along the arm. It will come off the hook.
  4. Remove the old blade completely, holding the arm with your hand. Do not let the metal arm snap back against the glass.
  5. Take the new blade and insert the arm's hook into the blade's mounting slot until the lock clicks.
  6. Check that the blade is secure. Give it a light tug to try to pull it off the arm. It should not come off.
  7. Lower the arm back onto the glass with a smooth motion.
  8. Repeat steps 1-7 for the passenger-side blade.
  9. Turn the wipers on at low speed and check for skipping, squeaking or chattering.

Common mistakes and warnings

  • Do not leave a metal arm without a blade standing in the upright position
  • If it falls, it can crack the windshield
  • Always hold the arm with your hand when removing and installing the blades
  • If the new blades leave streaks, wipe the rubber edges with a clean cloth and isopropyl alcohol, and degrease the glass
Spotted a mistake? Tell us →