← Chevrolet

Chevrolet Cavalier, 2.4 L, 1999, automatic transmission - error P0502 speed sensor

Chevrolet Cavalier · 1999 8 answers Translated from Russian · original

The check engine light and the transmission light are on. There is only one error, shared by both systems: P0502 speed sensor. I captured the sensor's signal with an oscilloscope but I can't make sense of it. I think the sensor is faulty. The scope capture is attached. Can someone tell me whether the signal is correct or not?

Answers
O
Owner May 29, 2020

The signal is clearly wrong. It should be a clean sine wave. It looks like the wire is shorted to something else, most likely a ground rather than a signal wire.

O
Owner Jun 24, 2020

Do you know the amplitude? Could something be wrong with the reluctor (tone) ring?

O
Owner Sep 26, 2020

I checked the wires from the speed sensor to the control unit, and they arrive at the wrong pins. I unwrapped the harness under the radiator. In the accident the whole bundle was severed there, and it was soldered back together by color, but there are 4 yellow wires and they were connected incorrectly. I put them in their proper places and that fixed it. The speedometer and the temperature gauge came back, and the transmission now shifts properly. Everything seems fine, but a new error has appeared: P0730, incorrect gear ratio. The transmission was replaced, because the previous one was destroyed in the accident. Can someone explain this error? It seems to be a calculated one, but I don't know what is compared with what.

O
Owner Oct 25, 2020

In plain terms, "incorrect gear ratio" means the transmission is slipping.

O
Owner Nov 27, 2020

We drove it on the highway yesterday. It accelerates and shifts normally. If you lift off the throttle at 120 km/h, the revs drop to 1000. I think the torque converter lock-up isn't working. Could that cause P0730?

O
Owner Sep 03, 2021

I don't know much about automatic transmissions, but the point of the error is that the transmission control unit compares the speed at the transmission input and output, and sets P0730 when they don't match. For example, here is how it reads for Opel: the ratio between the output speed of the automatic transmission and the turbine speed deviates by more than 10% for more than 5 s. Vehicle speed is above 25 km/h. Selector lever is in position D, 3, 2 or 1. Engine speed is above 400 rpm. Transmission fluid temperature is above -30 °C. Throttle opening is above 10%. Action: limp-home mode is activated. The malfunction indicator is on. P.S. The input speed (turbine speed) is the torque converter speed.

O
Owner Oct 05, 2021

Thanks, I understand it a bit better now. The TRAC OFF light comes on only when you start moving, then goes out after about 3 minutes and doesn't come back. I passed the explanation on to the customer, but as far as I can tell he doesn't care. It drives, and that's enough for him. He searched a long time for this transmission, so that's his business.

O
Owner Nov 01, 2021

Test the transmission under hard acceleration. After this error it should, in theory, report which gear's clutch pack is slipping. After that it's either the valve body or the friction clutches.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →