← Volkswagen

Polo 2005, BKY 1.4L - No spark and no injector pulses

Volkswagen Polo · 2005 7 answers Translated from Russian · original

A car came in with an obvious misfire, no fault codes. I pulled the spark plugs and one was wet with fuel. I checked the compression, and after that the car won't start at all. I tried VAG-COM 3.11 and it didn't connect to the engine ECU (it has a Marelli). The other systems connected without problems, and I read the data with an ELM adapter. There are no immobilizer faults, and the indicator on the instrument cluster behaves normally. There is no spark and no injector pulses. What a mess...

Answers
O
Owner Feb 14, 2021

When you measured, did you unplug the connectors from the coils? How did you disable the spark? Be detailed and honest.

O
Owner Feb 22, 2021

Yes, I disconnected all the coils at once.

O
Owner Mar 10, 2021

Did the compression at least stay OK? There are no miracles. First you need to calm down; the only people who don't make mistakes are the ones who do nothing. The least reliable parts are the immobilizer and the alarm.

O
Owner Mar 21, 2021

I'd check the ECU power supply and grounds, and the fuses. It looks like there is no power, which is why it doesn't connect. Or there is no power after the ignition switch, terminal 15.

O
Owner Apr 03, 2021

Check the fuses. If power and grounds are all OK, you just need to clear the fault codes. These control systems (Marelli), after finding an open circuit in a coil, shut that coil off completely. Clear the codes and it's all fine. As for the original problem, first you need to get it started. Once it starts, check the coils. They often fail on these engines. But don't switch the ignition on with the coils disconnected. The unit will cut them off.

O
Owner May 26, 2022

The alarm has nothing to do with it, I checked it first. The fuel pump runs while cranking, and power reaches the ECU. Through the OBD port the unit is seen and I get data from it. Power reaches the coils and injectors. What's missing is specifically the control pulses to the coils and injectors. What bothers me a lot is why VAG-COM doesn't see the ECU. It says it can't synchronize the connection.

O
Owner Jun 30, 2022

Does the warning lamp at least light up when the ignition is switched on? Check whether there are pulses coming from the unit. But most likely it's the wiring. Is there an adapter connector for the injectors, coils and so on?

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →