← Volkswagen

VW Touareg - no charging at idle

Volkswagen Touareg 5 answers Translated from Russian · original

Hello! It's all in the thread title. VIN XW8ZZZ7PZDG005999. When engine speed is raised, the alternator charges and the output rises in proportion to rpm. That is, if the car is held at 2500 rpm, up to the cut-off, the voltage is about 14.7 V. When you drop back to idle, the voltage falls until the car shuts down completely. The customer took this problem to a friendly shop back in the summer. They replaced the voltage regulator and the battery, but the problem, as I understand it, did not go away. What I have done: 1. Checked the power and ground supplies according to Elsa. 2. Charged and tested the old and new batteries. 3. Checked the LIN signal reaching the alternator with an oscilloscope - it arrives. 4. Before the car starts to drop into a power supply fault, there are no fault codes. 5. I have an old factory alternator test stand, but the alternator does not start on it at any speed, even with the original battery. 6. Took the alternator to a specialist alternator and starter repair shop. They put it on their stand and it works: it charges at different speeds and under different loads, in my presence. 7. I see no problem with the overrunning clutch pulley. So I am asking for help solving this problem.

Answers
O
Owner May 31, 2022

First of all, you need to use the oscilloscope to look at the alternator control. I created a thread about this maybe half a year ago. On my Audi the alternator also kept dropping out intermittently and there was a communication error with the control modules. The cause turned out to be a flooded crankshaft position sensor connector.

O
Owner Jun 04, 2022

According to Elsa, the control signal goes to the alternator from the diagnostic interface J533 over LIN. I put the oscilloscope on the LIN input at the alternator, and the signal is there. There are no communication errors between the control modules.

O
Owner Jun 12, 2022

Don't rule out a turn-to-turn short in the windings.

O
Owner Jun 18, 2022

1. Disconnect the LIN connector. In emergency mode the alternator should work without external control, like a normal alternator, i.e. hold 14.5 V. I haven't tested this on these cars, but you can check it on the car. If it gives 14.5 V at 2500 rpm without LIN, it should give the same at idle. Or at idle with no load, 14.5 V. 2. A Touareg at idle draws 15-25 A. On the car: take the load off the alternator. Check the voltage at the terminal. If it is 14.5 V, connect something drawing 1-2 A. See how the voltage behaves. Then continue in the same way. If the alternator is not delivering 20-30 A at idle, it is faulty.

O
Owner Aug 25, 2022

1. I disconnected the LIN connector. Result: there is still no charging at idle, and as the rpm goes up the voltage rises in proportion to 14.7 V. The alternator doesn't get hot and there is no unusual noise. I can see visually that the rotor turns together with the overrunning clutch pulley. For the load tests I did the following: with the engine running, I took the load off the alternator by disconnecting the positive power cable at the point used to connect a charger, and connected it with crocodile clips to another battery, with the ground connected to the car ground. Charging at idle then appeared. On this same alternative circuit I put a load on at idle in the form of 50 W lamps. After the first lamp was connected, the voltage immediately sagged to 13 V, and when the second was connected it collapsed. So the alternator is scrap! Thanks everyone! Many thanks for the troubleshooting method.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →