Mitsubishi L200 2.5D: sometimes smokes and won't drive
The vehicle is a 2012 model. Sometimes the following happens: when shifting from 1st to 2nd gear, the check engine light comes on for a second and the vehicle stops driving. It won't rev past 2,000 rpm, heavy smoke pours from the exhaust, and the engine shakes at idle. If you switch it off and restart it right away, everything works normally. It happens only on the 1st-to-2nd shift and doesn't show up in other gears. The fault isn't stored, and the engine module is clean. In half a day of driving around the workshop, the defect appeared once, and the scanner showed no fault code. The vehicle is under warranty, and the dealers found nothing: no errors means everything works, in their view. The customer replaced the EGR valve himself, and nothing changed. Where should I look next, and where should I start? Has anyone run into this defect?
How can the car turn on the check engine light and not log a fault? That doesn't happen. Was the firmware checked for originality?
I had a couple of cars with a similar headache, though they were 2008. On one I fixed the problem by replacing the overflow valve on the high-pressure fuel pump. On the other I fought it to the bitter end: I fitted ALL new fuel system parts, did the small injection quantity adaptation and injector coding and a service, and got zero result. The needle just stopped at 3000. Until I reflashed it with a no-EGR map, the car wouldn't pull (updating the software was tried, with no effect).
It does happen. The check engine light comes on for literally one second. I immediately press read faults, and there's nothing there. I'll go and check the firmware now.
I read out the firmware, 1860B578_04. There are no differences from the stock one in the database.
Still try checking the valve and doing a service, especially since you say black smoke is pouring out.
Is the catalytic converter clogged? If it's still fitted, of course...
Look at the data list for fuel and air.
It looks a lot like the metering valve. There was a similar situation on a KZ. I connected an oscilloscope, adjusted that valve, and that was the fix. Does it have a mechanical adjustment? Also, was the fine fuel filter changed recently? If it's a Chinese part, then it's worth checking the screen at the high-pressure fuel pump inlet. I take it the engine is a 4D56?
It looks more like the EGR than the fuel system.
The EGR is new and original, and it hasn't done a thousand yet.
Then take logs for air and fuel at the moment of the glitch. Check the joint of the pipe to the intercooler and all the boost pipes. What color is the smoke? Automatic or manual? If it's an automatic, are there any faults in it? Which scanner? A simple Launch and Autocom read these engines fine. PS. In general, you need to keep pressing the dealers, since it's under warranty. Although they may refuse on the fuel side.