Mitsubishi Carisma 1.8 GDI 1998 - Can't communicate with the ECU.
Hello everyone! The car is a Mitsubishi Carisma 1.8, 4G93, 1998. Does anyone have the exact ECU pinout, specifically the K-Line on the diagnostic connector? I can't communicate with the ECU. On the diagnostic connector itself: pin 1 and pin 12 are present, pins 4 and 5 are ground, pin 16 is 12V, but pin 7 shows 8.6 V. So I want to take the K-line directly from the ECU. Autodata has a diagram, but the wire colors don't match. I checked with an oscilloscope. The voltages differ, and it switches off with a larger time difference, so I think the pinout is wrong. In reality, the K-Line wire at the connector is yellow with a white stripe. There is also a single-pin connector nearby, and I tried to communicate through it, without result. In Autodata it is pin 79 on the ECU.
Open up the unit and take any Mitsubishi manual. Everything is described there. Finding the K-line and the boot pin yourself is definitely faster than searching for the pinout.
There is no K-line there in the form you are looking for. There are lots of pinouts and few matches. You'll have to search by trial and error.
It should go through the immobilizer. Pin 1 is also involved in diagnostics.
Surely there can't be 8 V on the K-line? That's why I wanted to connect directly to the ECU, but I can't find it on the ECU.
Where would an immobilizer come from on cars of these years? Especially if it's right-hand drive. I don't think GDI was fitted to European-market cars back then.
It's left-hand drive. Autodata shows an immobilizer, but the Tolerance doesn't. Tomorrow I'll look at the pump-up.
There are most likely 2 units, one main and a second one for the injectors. Look in the front passenger footwell, under the mat.
Yes, I called the person, and he says an immobilizer is fitted. He'll come tomorrow, and I'll try it together with pin 1. The main thing is to find the diagnostic pin on the ECU.
Then post a photo of the ECU circuit board!
Most likely it's standard, next to the wire going to pin 1. If the car starts, the K-line reaches the ECU, and there's no need to look for it.
I've let the car go, and the owner should come in the near future. I'll try again, and if it doesn't work out, I'll send a photo of the board.
On a Mitsubishi Space Wagon 1999 2.4 GDI I had to disable the immobilizer.