← Opel

Corsa D, 2008: replacing the electric power steering sensor

Opel Corsa · 2008 13 answers Translated from Russian · original

The two brushes in the position sensor are completely worn down. I tried pressing them tighter, which didn't work. The whole sensor has to be bought. Here is my question. My EPS unit has the sensor wiring running along the top, on the outside. On classified ads, it looks like all the units are not like that but the second type. Are they interchangeable? Or do I need to look specifically for a Delphi unit with the sensor wiring on the outside? P.S. If anyone happens to have one lying around, either the whole unit or ideally just the sensor.

Answers
O
Owner Mar 07, 2020

We buy the sensors separately, brand new. They are the same as the original ones. Message me tomorrow, I'm not working today. I'll ask the parts buyer for the part number.

O
Owner Mar 24, 2020

Prices: a used complete EPS unit is 10-12k rubles. A new SENSOR is from 10k.

O
Owner Apr 01, 2020

Opinions differ. One respected person says a new-style sensor won't work, because the connectors are completely different. Another, whom I also respect, says only the third connector is missing, and the other two are identical.

O
Owner Apr 29, 2020

I had a customer with a Meriva A who replaced the sensor himself. He says the sensor he installed wasn't the same type. This is all from his word, of course, I didn't see it myself. Everything works.

O
Owner May 29, 2020

I also wanted to help a person and ordered a VAICO sensor for a Corsa D. The steering wheel stopped jerking, but it pulls hard to one side. In the end I took the sensor on myself. Now it's only the complete unit, or a sensor, but only the customer's own.

O
Owner Jul 10, 2020

An acquaintance of mine replaced one. He says it's fine and works.

O
Owner Aug 03, 2020

It comes down to the installation. When fitting it onto the shaft, you can put it on with a slight offset (the slot on the shaft is somewhat wider than the lug on the sensor). That's the only way it goes on. Switch on the diagnostic software, fit it, and look at how many newton-metres the sensor shows. At a value of ±0.3 Nm it will work correctly. If not, the steering effort will differ left and right. Sometimes it takes an hour of fiddling to get it right.

O
Owner Sep 19, 2020

There are a lot of variants. Send a photo of what is fitted and what you want to install. There are completely different versions. It's hard to remember without a photo.

O
Owner Apr 08, 2021

Send your sensor to a friend and let him experiment. If it all works out, I think he'll pay.

O
Owner Sep 16, 2021

Here's an example. Different connectors, a different number of wires, different lengths of the leads, different pin-outs, and so on. Some may be interchangeable, but I haven't held all of them. Of the ones I've handled, they were not interchangeable.

O
Owner Apr 17, 2022

That's why I want to buy the steering unit complete, so I don't have to bother with it.

O
Owner May 17, 2022

About 5 years ago I had the same thing. I ordered a non-original one from eBay in Italy. It was a pain to replace, but the car accepted it and worked. It then ran for about 3 years until it was sold. The number was somewhere in the history.

O
Owner Oct 26, 2022

There's no difference between 2 or 3 connectors.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →