← Chery

Chery Amulet - Check engine light on, code P0508

Chery Amulet 13 answers Translated from Russian · original

Need help figuring out a Chery Amulet. The ECU is a Bosch 797+. The check engine light is on with code P0508 - idle air control (IAC) circuit voltage too low. I tested the idle air control valve and the wiring from the ECU to the valve, and found nothing wrong. A new valve was tried as well. I opened the ECU and tested the connection from the L9935 to the connector, and it was all fine. Diagnostics shows 0 steps and the idle speed is slightly high. When the ignition is switched on, the valve tries to extend a little (a small jerk) and then stops. A Ya7.2 ECU was tried, and the idle air control valve works with it. Then I put the original ECU back and, amazingly, everything worked. But the joy was short-lived. After a few starts the fault came back. After all of this I suspect a fault in the control unit, more precisely the L9935 chip.

Answers
O
Owner Oct 15, 2020

Was there any overcharging or undercharging on the car, or was it jump-started? That could have burned out the chip.

O
Owner Oct 31, 2020

As for overcharging or undercharging, I don't know for sure, but I think not. It wasn't jump-started.

O
Owner Nov 13, 2020

Possibly an air leak bypassing the idle air control valve.

O
Owner Nov 25, 2020

So the wiring isn't the cause.

O
Owner Jun 11, 2021

A side question: will a VAZ Bosch 797+ work on this car if the Amulet firmware is loaded into it?

O
Owner Jul 05, 2021

And it indirectly points to a fault in the idle air control driver in the ECU. Just thinking out loud, but this needs checking...

O
Owner Sep 08, 2021

Possibly the idle air control valve itself has an open circuit (one of the windings). Drivers rarely fail.

O
Owner Oct 07, 2021

A new valve was tried. No change.

O
Owner Nov 01, 2021

When the new valve was tried, was the ECU re-initialized (battery terminal disconnected, ECU connector unplugged)?

O
Owner Jan 10, 2022

I re-initialized the ECU (with Scandoc).

O
Owner Jun 10, 2022

So what about re-soldering the connector on the original ECU and the chip itself? After it was removed and reinstalled, it worked. Why?

O
Owner Jul 26, 2022

No, it won't work! If you install a VAZ 7.9.7+ with firmware from a VAZ 8-valve 1.6, the engine might even start, though you may also need to disable the immobilizer... Naturally it won't run properly, but you can try it as a test. Still, the cause is most likely an air leak bypassing the idle air control valve. The ECU tries to compensate for the air bypassing the valve and sets the valve to 0 steps, but apparently even that isn't enough, which is why the idle speed is high.

O
Owner Sep 08, 2022

I re-crimped the connector on the ECU and re-soldered it on the sensor side. My suspicions are: 1. there is a micro-crack on the ECU board (the problem is that almost all the needed traces run under the ECU connector). 2. a problem with the chip. 3. damage to a wire in the harness, although that's unlikely since I tested it with a multimeter and a 5 W lamp.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →